32" hotr 90+mph
Collapse
This topic is closed.
X
X
-
Me,that I know of.75mph and ran out of water. No air dam. It's the silver cat in my avatar.
-
Nice Yamaha!!!Originally posted by Howard Lee View PostI will show you how i balance my boats. First you need to run the boat and find a good spot to start from. Then make a mark on the boat where you balanced it at. Run the boat and check your speed. Now move the batteries only a 1/4 of a inch at a time. This might take some time to find your best balance. Also your prop angle needs to match your balance. Think of your prop as if its drawing a straight line. If your prop angle is to high, you will have a nice rooster but this will not be the fastest setup. This might help some of the less experienced.
Leave a comment:
-
Make sure you have continuous vid of the run with the GPS in the boat so we can see this fast boat perform up to your expectations...................Originally posted by Howard Lee View PostIf the weather is good this weekend i will make some test runs and a video.
Leave a comment:
-
If the weather is good this weekend i will make some test runs and a video.
Leave a comment:
-
I will show you how i balance my boats. First you need to run the boat and find a good spot to start from. Then make a mark on the boat where you balanced it at. Run the boat and check your speed. Now move the batteries only a 1/4 of a inch at a time. This might take some time to find your best balance. Also your prop angle needs to match your balance. Think of your prop as if its drawing a straight line. If your prop angle is to high, you will have a nice rooster but this will not be the fastest setup. This might help some of the less experienced.
Leave a comment:
-
In theory all he needs is 6S and a v942/3 prop to get there. It would be a SAW-only setup and would stress the ESC (what ESC is he using?), but it is possible in theory. I doubt the boat could set a record but it might hit 90 on the GPS....but not with the CG so far back.....84 mph with a Leopard 4082 doesnt compute in my little brain...
.
Leave a comment:
-
Is from Fine Design.Originally posted by 6sHyper View Postwhat kind of rudder is on there??
Leave a comment:
-
I was just thinking if the hull was not square the very rear of the boat would be the best place to start from.Originally posted by LarrysDrifter View PostYou should measure from the rear of the sponsons.Same place where a stinger would mount if it were a twin drive.
Leave a comment:

Leave a comment: