JAE Builds

[HOTWATER]

I'm glad you decided to pull the trigger!!!

Good luck!
Doug

PS. I don't have a explanation for the tubes guys except we must be faster than you.
We haven't experienced a problem with the turn fin but I've heard that Dick Tyndall is "the man."

I think David Pruese is making fins also (I believe Martin is using them). Stainless would be good...much stiffer...

Man Doug... you have a rigger factory going on there! Good stuff!!

-Kent

[Gerwin Brommer]

How a small country can think big :-) :
A member on our Dutch board has scaled de JAE up to 50 inch (length).
Motor will be a Lehner 3060/10 on 12S2P and 12S1P for saw.

[Darin Jordan]

How a small country can think big :-) :
A member on our Dutch board has scaled de JAE up to 50 inch (length).
Motor will be a Lehner 3060/10 on 12S2P and 12S1P for saw.

That has got to be ONE UGLY BOAT!!

[Doug Smock]

I think David Pruese is making fins also (I believe Martin is using them). Stainless would be good...much stiffer...

Man Doug... you have a rigger factory going on there! Good stuff!!

-Kent

You're right, David makes the fins that Kentley is running also. I was trying to remember his name.

Be sure to post some pics and vids of that beautiful beast Gerwin!

Thanks,
Doug

[BakedMopar]

My boat came in today. Need to finsh up the Rico then I will get started on her.

[Brushless55]

What speeds are you guys getting with the UL-1 motor?

[Chilli]

Anyone have a contact # or email for David Pruese?

[Eric Bourlet]

What speeds are you guys getting with the UL-1 motor?

Still playing with props and poor 2 Cell R/C car packs 2 of them in series 60 MPH at the end of the straits. EagleTree GPS used to measure. Will try again this weekend with better batteries ,and a few other props.

[RayR]

Anyone have a contact # or email for David Pruese?

David Pruesse

CDrace@rocketmail.com


All the best,

Ray

[Chilli]

Thanks. I remember reading the posts about David on IW and tried to do a search. I figured the spelling might be off.

Mike

[Brushless55]

who builds and sells these minus motor and esc?

[Doug Smock]

who builds and sells these minus motor and esc?

I spoke with Joe this week about the number of people that have contacted me about building these boats. He has contact information on some builders give him a call or shoot him a email.

Email: sales@zippkits.com

Phone (Toll Free): (866) 922-9477

I would build one for you but I have some other projects when I get these finished.
More pics coming up.

Doug

[Brushless55]

Thanks Doug!

[Doug Smock]

Almost there.

Servo mounts are built and installed, skis are built, sealed and have floatation installed, stuffing tubes are in, battery trays are ready to be installed, the inside of the tubs are sealed, and the outside of the tubs and the sponsons have one coat of epoxy on them. Next the skis go on and finish sealing.
I should have these ready to go by mid week. Tomorrow I'm going to the pond!!

Doug

[BakedMopar]

Does both sponsons have the same AOA?