another mean machine set up

[Alexgar]

bustitup is that a cen motor mount i have one laying around i was going to put in my next build(vee of some sort)

[Brushless01]

Hi how far from the back of the boat is the motor i might build one with a 7xl on 4s. And where do you mount your drives ??

Thanks

[rearwheelin]

This video is the reason why I bought my MM !
http://www.youtube.com/watch?v=XEjJRiPyEyM

lol.. that looks like my old boat i traded for some home improvement labor !

[Brushless55]

I'm thinking of ditchin the 540XL motor idea and going Medusa..
any suggestions on what Medusa to use with 4s and 6s ?
I'm hearing more and more great reports with the Medusa motors..

[bustitup]

well she looks much cleaner without the radio box and the wires cut nice and short

look any better?

thanks to all who talked me into getting rid of all the garbage

[Brushless55]

In the photo is was set at 9"

I'm new with cats, and I love this cat!
turns sharp and runs super smooth..

[bustitup]

Thanks!

it seams very tight to the water, not sure if this is how is should run?

9" is just about right for that boat...I use 9 1/2"
but are you balancing it properly?....I measure off the transome towards the front of the boat and put a mark at 9" (in your casr) in the side of the boat...I use the table edge and drab the transome towards me 9 1/2" ..the boat must balance or teeter totter at the measuring point...just shift the batteries forward or backwords to get it to balance on the mark you made......instead of a table edge you can use something perfectley round like a broom stick centered on the mark you made

hope this helps....if you have it balanced perfect it should ride just right

[bigpapa]

nice rooster tail !!!!!!!

[bigpapa]

looks good may loosen it up a little

[Brushless55]

Thanks!

it seams very tight to the water, not sure if this is how is should run?

[DISAR]

Congratulations!

[Brushless55]

My first run with my MM, and wow! Cats are so cool!

not sure if it looks like it is running through the water right?

my cog is at 9"

[Brushless55]

it.... is.... Finished!

[bustitup]

I don't use any card,I just use the tx instead, its simple to program. So, have u set the cutoff voltage that I've suggested to u?

no not yet...i'm just putting the boat back together from tearing it apart

[Mel279]

Mel what are you using to program your 180?.....card or tx
if your using card do you have a pic of it?
here is what i'm using its ver2


http://cgi.ebay.com/ws/eBayISAPI.dll...lenotsupported

I don't use any card,I just use the tx instead, its simple to program. So, have u set the cutoff voltage that I've suggested to u?