Motor choice for 6s jae 33

[jim82]

Chinahobby 3s 5000mah x2.IMG_20180312_173439140.jpg.

[chevelledude]

Heres how I did mine. Used a straight edge razor and cut the original back top piece. Then added long triangular wood pieces to raise deck. Glassed it from inside. That is a zippy compact 5000 60c in it. Made sides on the bottom and put velcro on battery and sides. Lid taped on holds battery fine. Boat runs so nice.

[urbs00007]

Heres how I did mine. Used a straight edge razor and cut the original back top piece. Then added long triangular wood pieces to raise deck. Glassed it from inside. That is a zippy compact 5000 60c in it. Made sides on the bottom and put velcro on battery and sides. Lid taped on holds battery fine. Boat runs so nice.

what are you running for power? speed and run time?

[rol243]

i noticed the zippy compact 5800 4s is higher than the hrb 6000 / 4s. so the zippy needs a higher lid where as the hrb doesn,t. I like your jae chevelledude.

[chevelledude]

Iam running a TP 3650/4y and thats a 6s in the boat. Because the gear seems to work so well together I just bring it in after about 10 or 12 good laps. It just a little warm to the touch. I dont do gps runs with it but years ago I had a crapshooter that a nice police officer radar gunned for me at 75 then told me I have to leave. Its at least that fast. I Thank Fluid for the setup in the 2 post. Good call

[rol243]

great old rigger the Crapshooter.

[jim82]

IMG_20180314_003857475.jpg. I'm hoping not much longer!

[rol243]

Your getting there Jim.

[jim82]

IMG_20180321_114824436.jpg should be ready by the weekend!

[rol243]

should go very well on 6s Jim , my jae-33 goes nice on 4s.

[urbs00007]

[ATTACH=CONFIG]157848[/ATTACH] should be ready by the weekend!

any chance of more pictures as you finish this boat. I'm building same boat using leopard 4082, seaking 180 on 6s. thanks

[jim82]

should go very well on 6s Jim , my jae-33 goes nice on 4s.

I'm going to start with a 3650 2060kv mostly 4s but try a few 6s passes. I have a few more motors I am going to play around with eventually

[jim82]

Nah only took a couple pics I should have did a small build thread. Only thing I did different I didn't use any of the battery tray stuff and added trim around the edges on the deck of battery area.

[rol243]

the 3650 - 2060 should be great on 6s for some saw. I think it was Fluid who mentioned a 3650 powered rigger has done 140 mph. i have a t.p. 3650 - 2350 kv motor to run on 4s some day.

[jim82]

IMG_20180322_132712146.jpg