Motor choice for 6s jae 33

[rol243]

What is the max width and height lipo that will fit?

3 1/2 inches wide x 2 inches high. this height measurement is without the battery tray fitted, just velcro to floor is fine or velcro to sides if using 2 x 3 s packs.

[urbs00007]

can anyone recommend a prop for my setup? leopard 4082 1600 kv. 6s 5,000 mah. seaking 180. thanks

[jim82]

I'm trying to find an h-7

[jim82]

3 1/2 inches wide x 2 inches high. this height measurement is without the battery tray fitted, just velcro to floor is fine or velcro to sides if using 2 x 3 s packs.

Ty. For the measurements

[jim82]

I may end up with https://hobbyking.com/en_us/turnigy-...E&gclsrc=aw.ds

[rol243]

I would try and get a larger MAH pack than 4000 . zippy compact 5800 is about the same size or HRB 6000 .

[rol243]

I'm trying to find an h-7

O.S.E. parts store are out of stock, maybe find out when more are available or i know Hobby Supplies Australia have the H7.

[jim82]

I would try and get a larger MAH pack than 4000 . zippy compact 5800 is about the same size or HRB 6000 .

looking for something other than zippy compact 60c not a big fan. I have some Turnigy hd's and they work pretty well but still looking atm.

[jim82]

Kit arrived yesterday I'm hoping to start on it tonight

[rol243]

jim, if your going to run 6s you might need to not fit the battery tray as height can be limited . just check before you glue up.

[jim82]

jim, if your going to run 6s you might need to not fit the battery tray as height can be limited . just check before you glue up.

I will ty sir

[jim82]

So should I leave the battery tray mounts out too? This is where I am IMG_20180312_111343131.jpg

[jim82]

I kinda answered my own question if I do use them my lipo is not going to fit. Just worried a little about tub strength without them.

[rol243]

You can fit the 3 x cross rails but cut the center area down so the floor piece sits down almost to the tub floor, this way you have the extra strength and the side cut outs will be filled in. like you jig and clamps set up.

[jim82]

I am going to add square strips to sides and maybe some wood filler to fill the holes on the outside.IMG_20180312_172304980.jpg