Zonda build

[ade-rc]

New to RC boats, new to this forum, so diving in with a Zonda build.

[ade-rc]

20170428_073904.jpg

20170428_073919.jpg

Blank hull ordered from Hong Kong.

20170428_073929.jpg

Drive line mock-ups started

[Prodrvr]

Question...is that motor mount going to fit in the sponson at the correct angle, or do you have to mod it?

[Mxkid261]

Are you setting this up as a twin?

[ade-rc]

It has slots in the sides so can be adjusted somewhat. But mod'ing it is also on the table.

[ade-rc]

Are you setting this up as a twin?

Yes twin, other screw is in the picture on the balancer. First ever boat build, so hopefully will be fun building and learning.

[hughb]

Looks really nice. All the best with you build. I have a CF Zonda too i wish to rebuild when time allows

[ade-rc]

Looks really nice. All the best with you build. I have a CF Zonda too i wish to rebuild when time allows

Thank you. Should be a fun build.

[Beaux]

Nice going. Good luck, there's a lot of good info on here.

[ade-rc]

Nice going. Good luck, there's a lot of good info on here.

Thanks. Will probably be scanning for build info as it moves along.

[ade-rc]

20170508_212305.jpg

RH driveline started. Need to ream out the stinger for the stuffing tube. A bit tight and not going to force it.

[Prodrvr]

Before you go reaming, what diameter are the shafts and tubes?

[ade-rc]

Before you go reaming, what diameter are the shafts and tubes?

Stuffing tube fitted nicely in LH. RH had burrs so reamed them out and fits perfect now. (9/32 brass for 0.187 Teflon)

[Beaux]

Just checking if you got a left hand drive cable...

[ade-rc]

Just checking if you got a left hand drive cable...

Yes a LH and RH. Does anyone have estimates of length change at full RPM