Zonda build

[Prodrvr]

Yes a LH and RH. Does anyone have estimates of length change at full RPM

3/16" cable...leave a 3/16" gap between the end of the stinger and the back of the prop dog.

[ade-rc]

3/16" cable...leave a 3/16" gap between the end of the stinger and the back of the prop dog.

Thanks, Don't remember seeing gaps that big when researching boat builds. Was planning on maybe 0.040"-0.050" with a Teflon washer. Will need to dig deeper.

[fweasel]

Thanks, Don't remember seeing gaps that big when researching boat builds. Was planning on maybe 0.040"-0.050" with a Teflon washer. Will need to dig deeper.

That's not enough. No real need for the washer if you run a proper gap. I also just use the diameter of the flex as a guide.

[ade-rc]

That's not enough. No real need for the washer if you run a proper gap. I also just use the diameter of the flex as a guide.

Thanks for the info. Will make sure I have enough adjustment in the drive lines to accommodate the gap.