Next build: 37" Komodo

[srislash]

And I now possess a pair of SK 180's for this baby

Now time to tinker is another thing...

[tagasagwan]

Nice! those 180's should handle it! I thought you're gonna use the 120's from Keith? You beat me to it bud! lols!

[srislash]

I have already proved that the 120's won't have enough safety margin for this 11lb boat.

And didn't you say you found some?

[tagasagwan]

No! Scott was offering his sk120's for $50 or 55 each? The Egneg X442 L& R props for $55.

[srislash]

No! Scott was offering his sk120's for $50 or 55 each? The Egneg X442 L& R props for $55.

That is not bad Stephan.You should have tossed them in with my stuff that I got from him.

.

[srislash]

Well,this is the only decent install I could figure out for these SK's.I had to heat and lay the wires and caps over to facilitate cooling lines and the "stacking" process. This of course needs cleaned up and a nicer top plate made(i'm going thru this stuff like mad). Liberal use of Liquid tape also into play here.

[srislash]

Now I have no home for my ET in this "stack"Perhaps once it is setup I can step down to the SK 120's or 80's and the original layout.

[lenny]

Hey Shawn,
Nice octopus you have there,
You make it look easy sometimes.
Any ward on Scott, Or aka tiqueman single drive yet ?
I just picked up a Atomik 1100kv motor to do some testing with,
And compare it with a T600 in my 36" shockwave remodeling.
The shaft is 5mm not 6mm like the T600 and it turns a lot easier to by hand.

[srislash]

This better Len





You funny guy,very funny guy,LOL
The Komodo single is being done by Ray.

[lenny]

Yes, yes much better.
I thought Scott had one he was doing to.
Any snow boating their yet or snowmobiling ?

[tiqueman]

The Komodo single is being done by Ray.

Possibly not?

[srislash]

Possibly not?

He started it on Keith's site. How ya doin' Bud?

[lenny]

I thought their was a couple of them out there.

[Chrisg81983]

Hey Shawn,Nice octopus you have there,You make it look easy sometimes.Any ward on Scott, Or aka tiqueman single drive yet ?I just picked up a Atomik 1100kv motor to do some testing with, And compare it with a T600 in my 36" shockwave remodeling.The shaft is 5mm not 6mm like the T600 and it turns a lot easier to by hand.

@lenny a motor turning easier or harder by hand really doesn't mean much. My leos are hard to turn by hand and next to them are my castles or neu's. Then I have my sets of lehners that you can turn so easily its not even funny. It almost feels like there are no magnets in the motor. So basically what I am sayir is that a motors performance cant be judged by how easily you can spin it by hand. Thanks cg

[srislash]

She's all back together folks,just going to let some DuraLube soak into the cables.