MHZ Mystic 1380mm build

[Chrisg81983]

I got the 2240/7 they are 2114 I got the 6 connections on back as well

[Chrisg81983]

And yes I got a pair forgot to answe that one

[nata2run]

I got the 2240/7 they are 2114 I got the 6 connections on back as well

Well, awesome!! If you build it right and get it setup right, you have enough power to push this way over 100mph. Should be nice.

[drwayne]

re pm cf+2pk e.
Hey MrK .. will try to visit Tues, will call first c where u are.
MrW

[Chrisg81983]

That was my goal but most of the time i would like to keep it around 75 mph on 5s the then when desired step it up to 6s and then really be moving but I will do a build thread once it all gets here for now I will be watching yours Thanks Chris g

[nata2run]

Just a couple more images of the "little machines" with the thrust bearing installed. I love the look of the Lehners already!!

DSC03356.jpgDSC03357.jpg

[srislash]

They do look size appropriate in there.Mounts look good Kent.Or is it Trent .

[nata2run]

They do look size appropriate, but not PHAT LOL. Let's see if they got the power to get anywhere.

Trent

[jkr]

That was my goal but most of the time i would like to keep it around 75 mph on 5s the then when desired step it up to 6s and then really be moving but I will do a build thread once it all gets here for now I will be watching yours Thanks Chris g

If you run over 30.000 rpm your thrust must be ceramic.

[Chrisg81983]

Thanks for pointing that out you gotta love spell check on these new phones I do that about 20 times a day lol

[jkr]

Thanks for pointing that out you gotta love spell check on these new phones I do that about 20 times a day lol

Ooops!

[jkr]

nata2run

If you run over 30.000 rpm your thrust must be ceramic.

[nata2run]

Ghris, meet Trent... or is it Chris meet Kent .. I dunno...



2 things Kent
you need compressed air to blow out every bit of carbon dust from inside else the motors will ingest it, and get belly ache.
2nd thing.. do the air trick twice .. just to make sure.
W

All cool, will do and do regularly as well. What I ment to say with the carbon was... that I mixed some carbon dust with the epoxy (looks cool) and may be stronger dunno. Once im done drilling I will clean the hull inside in methonol. (and then blow compressed air again)

[nata2run]

The Doc. came to the rescue again today. He happend to have some CF cloth I could use. (Very minor amount used)
Wanted to get something strong for the tubes,s so got them wrapped in CF. Ideal would have been heat shrink and then get that to clamp around, but didnt have any big enough so used some cling film to wrap around as epoxy is setting off.

Many hours sanding and then polish should look nice. Here they are before applying the epoxy.

DSC03359.jpgDSC03361.jpg

[drwayne]

hahaha
nice
you could have asked this electronics engineer for heat shrink...........ya dope !
Ive got miles of it ( literally )
W