WTB 1/8th x .125 flex cables (2)

[Alexgar]

as stated above 5" or longer

[Jeff Wohlt]

1/8" stub shafts to 125 cable?

[Alexgar]

yes sir

[Jeff Wohlt]

That is a close fit....very close. Not sure I can drill those but will try a sample. How long of stub? 2" or 2.25"

[Alexgar]

got a cable thats about to quit on me and i need to get a cable for this hardware, ill used on my new cobra, Do you think it will work jeff
http://www.hobbycity.com/hobbyking/s...5mm_(Hull_Only)

[Alexgar]

2" should work

[Alexgar]

fdm sells hugheys but if some one had a few laying around that be great

[befu]

Are you sure? I run 1/8" stub shafts with .098 cable in my boats, easier to make.

It has been years since I have seen continuous diameter cables. Old way was to take a 1/8" flex cable, and cut the outer layer of strands off of the last 3/8". Then you measure the smaller inside cable and drill the 1/8" stub for that. solder it all together and polish the joint down to a continous diameter. We did this with 1/4" cable, but it should be the same.

Can't drill a 1/8 stub with a .125 hole, they are the extact same size! Go 1/8 stub with .093 wire.

Brian

[Alexgar]

i had a 1/8 to .098 cant hold the power of a fiego L class motor they just break first or second time out
http://www.finedesignrc.com/hardware/125x125cable.jpg

[bustitup]

I may have what u need....I will let u know when I get home

[Alexgar]

sorry i pm you i misunderstood your post send some pics to my yahoo

[Alexgar]

home yet bustitup?

[bustitup]

home yet bustitup?

sorry mine are 3/16" propshaft with .125 cable

[sailr]

sounds like you need to convert to wire drive

[Jeff Wohlt]

Yep, I can make you a 1/8 x 062 wire drive that will hold it.