Well to start everything that is in or comes with this boat was bought brand new within the past 4 months. I bought the hull from HK and have been building it up since. Here is a list of everything it has,
- Leopard 4082 2000kv motor w/ 40x50 leopard water jacket
- Turnigy 180 amp esc with the extra caps bank, also w/ programming card
- Grim Racer 45x68 sharpened and balanced prop
- HPI 2.4ghz tx/rx
- OSE Motley Crew upgraded .150 3/16 drive shaft
- OSE Genesis 3/16 conversion strut
- Aeromarine 5mm to .150 coupler
- Aquacraft Revolt upgraded strut bushing(installed), as well as a speedmaster 21 strut bushing
- Thrust Bearing
- Offset Rudder
- HK waterproof rudder servo
- OSE 1/4" water tubing throughout boat as well as spare 3/16" tubing
Also comes with, grim racer speed grease, transom water pickup, spare capacitator, 40mm rear motor clamp(one installed and one spare), water tubing clamps and water tubing Y splitter, spare water jacket o rings, Teflon liner, brass tubing, bulkhead fitting, spare connectors)
Has deans plugs installed and comes with a deans series connector, the motor and esc both have 6mm connectors installed
Nothing is wrong with the boat, near perfect besides a tiny bit of hatch paint off from tape and a small chip in the gelcoat on the underbody of the boat, the chip was covered over with epoxy so no worries there. There is Velcro on top of the battery trays as well as Velcro straps that go under the tray and over the batteries to hold them down.
I have $825 as well as countless hours into this boat in the past couple months. The reason for selling is I have decided to get rid of a couple of the toys to get a new motorcycle.
I am asking $675 shipped
Sorry for the poor picture quality, these were all taken with my ipad.
- Leopard 4082 2000kv motor w/ 40x50 leopard water jacket
- Turnigy 180 amp esc with the extra caps bank, also w/ programming card
- Grim Racer 45x68 sharpened and balanced prop
- HPI 2.4ghz tx/rx
- OSE Motley Crew upgraded .150 3/16 drive shaft
- OSE Genesis 3/16 conversion strut
- Aeromarine 5mm to .150 coupler
- Aquacraft Revolt upgraded strut bushing(installed), as well as a speedmaster 21 strut bushing
- Thrust Bearing
- Offset Rudder
- HK waterproof rudder servo
- OSE 1/4" water tubing throughout boat as well as spare 3/16" tubing
Also comes with, grim racer speed grease, transom water pickup, spare capacitator, 40mm rear motor clamp(one installed and one spare), water tubing clamps and water tubing Y splitter, spare water jacket o rings, Teflon liner, brass tubing, bulkhead fitting, spare connectors)
Has deans plugs installed and comes with a deans series connector, the motor and esc both have 6mm connectors installed
Nothing is wrong with the boat, near perfect besides a tiny bit of hatch paint off from tape and a small chip in the gelcoat on the underbody of the boat, the chip was covered over with epoxy so no worries there. There is Velcro on top of the battery trays as well as Velcro straps that go under the tray and over the batteries to hold them down.
I have $825 as well as countless hours into this boat in the past couple months. The reason for selling is I have decided to get rid of a couple of the toys to get a new motorcycle.
I am asking $675 shipped
Sorry for the poor picture quality, these were all taken with my ipad.
Comment