Do I Cut Them?

[LiPo Power]

I am upgrading Stiletto with Hyperformance Flex shaft and 3.5 Bullet Shaft Assembly:
http://www.offshoreelectrics.com/pro...prod=hpi-psa35
http://www.offshoreelectrics.com/pro...d=hpi-dc1563s2
Looks like the flex is a little longer than stock.
Do I need to cut the flex or is it going to work fine the way it is?
Thanks
Robert

[CHIEFY_44]

i did the same upgrade on my stiletto, you may need to chop a very little bit off the shaft, i am lucky hyperpeformance is only 20 mins down the road so i went to see them and he has a flex shaft there that fits without chopping it if u ring them and ask for the flex shaft with the dark spiral line on it it fits a treat. have you done the brass tube instead of the teflon?? if not i reconmend you do, if u look back at darin's set up bit in here he tells you how to do it and it really does make the difference.

[CHIEFY_44]

you could also make the flat on the motor shaft longer and move the collet

[LiPo Power]

Tank You, good staff....
Robert

you could also make the flat on the motor shaft longer and move the collet