Has anyone tried this yet?
-
-
that motor is only rated to 25a constant - almost picked one up until I found that out, I don't think it will handle the load very well. -
I've got this motor and esc in my RC air boat. But that's a different hull and characteristic.Comment
-
air boat is less load I would assume but could be wrong. I'm sure it would work if it was propped really lightlyComment
-
The airboat has MORE load due to water surface of airboat compared to monimono. I would put a Leo 2550kv on 3s and a 432 octura prop. Now with using a high voltage makes it easier on esc and as a whole will run cooler. Car motors will use 2S voltage and not burn up. Just my 2 cents.Comment
-
thanks, I'm still learning.Comment
-
well, I hit up the local hobby shop, and bought a 40A ESC. it looked the same as the AquaCraft 20A ESC. And unfortunately it didnt fix my problem. it'll run for about 5 minutes, then stops. Its like the motor wont spin, or has a spot where it wont turn. hard to describe. Guess I should get an inrunner for it and quit messin with the outrunner motor.Comment
-
Check your motor timing on that esc you got. Could be a issue. As out runners like higher timing generally
Sent from my iPhone 5Comment
Comment