HiModel 4s-8s 200 amp esc

[joker rc]

peek then lol before it burst it bubble were,s here ? i am in OZ ,, i placed order last night around 10 pm emailed me today stating item posted , so 10 -15 days i guess
anyway a friendly boater put me on to these ,only had 1 fail after 3 years ,

[LOVE6S]

I may get one too, any idea how long it might take to get here?

[ksm2001]

I'm sure they mean, it will burst at 650 amps

[joker rc]

these are water cooled now from factory thanks to fighter cat , claiming 650amp burst is a bit outrages , i be trying one for that price

http://www.himodel.com/electric/HiModel_GX_Series_200A_2-7S_ESC_W_5A_UBEC_GX200A-B.html

[Steven Vaccaro]

Me either.

Now thats the funniest thing I've heard all day. Thanks for putting a smile on my face.

[FighterCat57]

I'm not sure how this turned into a sale thread?

Me either.

[Steven Vaccaro]

I'm not sure how this turned into a sale thread?

[questtek]

Very Nice Offer. Congrats for opening the door to innovation and experimentiation which is what FE is all about. I learn as much from my failures as I do from my very few successes!

[FighterCat57]

Like I tried...

Did you ever get that to work? It looks like it's doable at that point.

[greenblast]

ray i tried a similar setup. i knew taking apart the esc was beyond me so i made 2 cooling plates with a tube on one side i slid 1 between the boards and put one on top with the second tube on the other side of the first.the plates were wider than the boards so eah plate touched the other tube. that old hextronic lasted a couple of years. i may dig out those plates and try again

[FighterCat57]

Yep. Just like that. Only installed by them.

[ray schrauwen]

Like I tried...

[FighterCat57]

FYI- I've asked the manufacturer to add center cooling plates and build a water cooled version of this ESC. Just thought I'd let ya know, so if ya see it. It's because I asked Suppo to do it. Getting in touch with their designer was the hard part. The most difficult was convincing him to do it.

I'll see if I can get him to send a few samples/photos, etc. They are really busy though and may take a few weeks/months.

[Brushless55]

I used Plasti-Dip and Arctic Silver epoxy...heatsink is from an electronics surplus store, drilled for the brass tubing.

I like that

[FighterCat57]

Maby ill switch to copper tubes. "THE HORROR, THE HORROR"

Honestly, you'll probably be OK with brass as long has you have some cooling and aren't pushing the limits of the specs.