HiModel 4s-8s 200 amp esc

[Brushless55]

Ok, how does one get more timming out of these escs?
my MM 9XL motor sounds slow..

[ksm2001]

I just bought HiModel GX 200 Opto no BEC and the manual for this model is different than GX 200 with BEC

GX 200 no BEC : http://www.himodel.com/en/rc_manuals_url.php?id=130

GX 200 with BEC : http://www.himodel.com/en/rc_manuals_url.php?id=181

Which one is correct ?

I took a look at both and from what I read its the GX 200 No BEC, it mentions it in the first part of the manual that this ESC does not have a BEC circuit. The other manual mentions that it has a BEC circuit.

Ken

[Jesse J]

Freakin weird. Plugged her back in and whizzzzzzzzzz . just needed time to think about it.

[Alfa Spirit]

I just bought HiModel GX 200 Opto no BEC and the manual for this model is different than GX 200 with BEC

GX 200 no BEC : http://www.himodel.com/en/rc_manuals_url.php?id=130

GX 200 with BEC : http://www.himodel.com/en/rc_manuals_url.php?id=181

Which one is correct ?

[Jesse J]

Sweet, thanks. Will try and report back. I must have done almost everything BUT that series of tricks.

thanks again
J

[785boats]

It's been a while since I've reprogrammed one, but I think that after 'Swiftly' opening the throttle, You then have to go to fully closed (brake position) & hold it there until you hear the 'Security beep' then release. Then the unit is good to go.
Note; by 'swiftly ' they mean move the throttle to the open position & let it go almost immediately, before you hear the security beep, otherwise it goes back into programme mode. As you have found.
So it's;
Pull the trigger then let it go before you hear the security beep.
Wait a couple of seconds.
Full brake & hold until you do hear the security beep.
Let go.
System is ready.
All the best.
Paul.

[Jesse J]

Reread this whole thread, and still need to ask my question:

Anybody know how to get the Himodel 200A noBEC controller to get OUT of programming mode?
Dad was running his vegas with the Tower Tactic radio on 4S packs and an 8XL with X640 prop (same as mine which hit 55mph) and his motor was not fully revving (maybe 30mph). So, I thought we should reprogram and heat up his timing (factory setting was 1deg).

So after learning the hierarchy of beeps, we got it programmed, but at the end where it says to "swiftly open throttle" it starts again at the first menu. I tried all I could think of and haven't gotten it to come out of programming mode. We can get it to work only AS IF it needed a Pistix (full reverse being neutral and any amount of movement on the trigger being forward).

Anybody have the secret? Repeat, the ESC was working normally before, just not winding up the motor. Thanks, J

[Rumdog]

Leave the red wire in on the non bec esc's.

[Tony]

I bought the 3-7 because i didn't want to use the internal BEC. But, if and when this one craps out. I'll get the 4-8cell.
BTW, the 3-7 cell doesn't have a BEC, but it comes with the red wire. Why is that?

Can someone please tell me how much amp i'm getting with this setup.
ESC Himodel 200amp 3-7 cell .
KB45-08XL 1600kv motor
prop x445
6S1P Lipo

[tth]

I definately agree with Ken. Go with the 4-8 cell controller. It runs cooler than my 3-7 for some reson???

[ksm2001]

I have the 3-7 cell that needs the pistix. My 4-8 cell will work on my Tactic 2.4ghz system.
Hope this helps.

That's strange, I have both the 3-7 and 4-8 cell esc's and both work, arm, and program fine using my Spektrum Dx3.0 with no problems and no pistix. But if your going to buy one I would suggest the 4-8 cell JMO.

Ken

[tth]

Yes I did try it with the tactic system. All the ESC did was beep it would not arm at all. Plugged in the pistix and it went through the sequence.

[Tony]

I have the 3-7 cell that needs the pistix. My 4-8 cell will work on my Tactic 2.4ghz system.
Hope this helps.

Did you use the 3-7 cell with your TacTic system? I have the TowerHobby 2.4ghz, which is same as the TacTic 2.4ghz. Its a good thing i do have the PiStix on hand. I knew it would come handy someday.

[tth]

I have the 3-7 cell that needs the pistix. My 4-8 cell will work on my Tactic 2.4ghz system.
Hope this helps.

[NORMKRIS]

HM200Esc.

A good friend of mine runs one with his Futaba FM with no problems. He did not need a Pistix.

Norm Kris Sr.