Mystic ARTR 1140mm 44" from Germany, how good is it.

[Speedfreek]

One recommendation is ABC 2216-3 CR which i am trying to get, and thanks.

[dmitry100]

That sure looks like alot of motor for those little esc's

[Speedfreek]

That sure looks like alot of motor for those little esc's

1526275969990256785967.jpg

I have pulled 380 amps out of them in a car, software is set up at 398 amps to cut out, isent that enough?

[rol243]

I think 2 blade props would be more suited for SAW.

[MarkF]

Yes 2 blade for saw and 3 for oval. I would go for 2218 or 2219 2 blade if your going for max speed.

Mark

[Speedfreek]

I think 2 blade props would be more suited for SAW.

Thanks

[Speedfreek]

Yes 2 blade for saw and 3 for oval. I would go for 2218 or 2219 2 blade if your going for max speed.

Mark

Thanks mark will have a look at them .

[Speedfreek]

Look what arrived today
20180514_213421.jpg
Just placed the ESC in there to see if the hatch shuts
20180514_190007.jpg
20180514_190015.jpg
What to do first

[MarkF]

Very nice. Should be a rocket when your all done.

Mark

[rol243]

Yes thats a very nice looking hull.

[Speedfreek]

Very nice. Should be a rocket when your all done.

Mark

It will be

[Speedfreek]

Yes thats a very nice looking hull.

Very sharp lines, like a knife , the one thing i did not like is the motor mount it is only 3mm should be 6mm, need to support the rear of the motor now

[Old School]

Very sharp lines, like a knife , the one thing i did not like is the motor mount it is only 3mm should be 6mm, need to support the rear of the motor now

My son purchased an additional pair of mounts from MHZ for his 114 so will laminate two mounts together to give him the required thickness.

[srislash]

Wahoo, there is gonna be some speed on here this year.

[Speedfreek]

My son purchased an additional pair of mounts from MHZ for his 114 so will laminate two mounts together to give him the required thickness.

Yea that's what i am thinking go thicker there and not worry about rear support mount.