cyberstorm spinning out

[montymike]

Interesting you say that, as I'm trying to figure out placement of stuff inside mine....


Sent from my iPhone using Tapatalk

Sorry luck I don't build boats just buy them and install electronic in them so I can't help on building side just observed the way the drive gear was installed.

[ray schrauwen]

Check bottom of the hull for hooks, or a depression near the back. If it has, it needs blueprinting.. Possibly...

[rayzerdesigns]

thanks guys..i have done the hull blue prnting..and actually shortened stinger..bigger turn fins..moved cog back and actually added a small skeg..boat was very good this past weekend at winter warmups..ended up winning p limited mono

[montymike]

How much did u shorten stinger? Thinking of doing to miine.

[Make-a-Wake]

thanks guys..i have done the hull blue prnting..and actually shortened stinger..bigger turn fins..moved cog back and actually added a small skeg..boat was very good this past weekend at winter warmups..ended up winning p limited mono

That's awesome!

[montymike]

Cool

[rayzerdesigns]

2015-02-27 18.51.52.jpg
pic from last weekend

[Make-a-Wake]

What motor and prop you have on your Cyber? I sure would like to see a vid of it running, I don't believe I have ever seen one running...........and running well for that matter.

[rayzerdesigns]

It's a p limited setup..aquacraft 2030 motor..I run a x445 prop for sprint racing..442 for offshore

[SlickZERO]

It's a p limited setup..aquacraft 2030 motor..I run a x445 prop for sprint racing..442 for offshore

Do you cut your props or just sharpen and balance them?

[Heath M]

It could also be as simple as to much steering, turn you travel % down on the transmitter.

[MarkF]

I have had a few of these boats and Heath is right. You need to turn down the rudder throw. Mine spun out every time until I turned down the rudder throw. Some of the big gas boats do the same thing with too much rudder.

Mark