Has anyone used this device?

[Make-a-Wake]

Curious if anyone has tried this.............

http://www.atomikrc.com/collections/brushless-escs/products/atomik-glitch-buster

[bozo586]

they work great with my boats----i used them this year on every boat i ran! didn't have any signal problems all year.

[tlandauer]

Yup.
I had a Traxxas Stampede that I upgraded with Novak BL motors and the servo would always glitch no matter what i did, put one of these on the Rx and it was great!

[Brushless55]

they work great with my boats----i used them this year on every boat i ran! didn't have any signal problems all year.

Sweet!
I'm going to pick up about 6 of these

[flraptor07]

Yup, when ever I have a glitch problem I use one of them and 99.9% of the time it cures it! At one time NitroRC was giving them away with every servo they sold, that's how I found out about them.

[3-UP]

What if you don't have a extra spot on your receiver ?

[rickwess]

What if you don't have a extra spot on your receiver ?

It works in the bind location as well. I use in in all my RCs (cars and boats). It's cheap insurance against glitches.

I wish Steve carried them. Kintec sells them (hard to find but it's right on the home page).

[kfxguy]

You can make them soooo easily......

Fyi, if you use a receiver pack or an external bec, you can put it on a "y". It works the same way a cap bank does with batteries.

[littlepooper206]

Can you make one as well? So you have an extra capacitor and just slaughtered it onto the wires itself.

[littlepooper206]

Solder

[kfxguy]

Can you make one as well? So you have an extra capacitor and just slaughtered it onto the wires itself.

Yes. When I get home I'll look at one and tell you what cap to use.

[rickwess]

It's only $4 at Kintec.

The cap is in the 3000uf range and anything over 10V. Easy to make it you have the female pins and connectors..........or butcher an existing cable.

[kevinpratt823]

I have been using them for years in many of my cars. Savox servos draw a lot of current, and Spektrum rx's are sensetive to low voltage, together this combination has become notorious for "brown outs", enough that AMain hobbies actually puts in a footnote warning on the Savox servos that suggests capacitors with this combo. It basically backs up a weaker BEC from voltage drop browning out the receiver under servo load. On my track, with very high speed/high torque Savox servos, every time I hit an "S" turn, where the steering went full left-full right, I would get a brown out and the ESC would have to reboot. The glitch buster would fix it with most, but so would a good external BEC, which I ran for higher voltage servos. I also never had the issue with nitro cars that ran a rx pack, and those had 2 of the same high speed/ high torque servos operating at once. I personally haven't had this problem in any of my boats, even the 2 with savox servos, perhaps because the use an rx pack, perhaps because the servos are slower, or maybe just not as much load, but they certainly wouldn't hurt. I have tried them in all my boats when trying to resolve reception issues, but they didn't help my particular issue. A simple "Y" harnesshttp://www.offshoreelectrics.com/pro...?prod=dh-1614f does the trick if all your rx ports are taken, like with the MR200.

[NativePaul]

No, I use Futaba FASST and get no glitches to bust.

[Doby]

No, I use Futaba FASST and get no glitches to bust.

Ditto with my Tactic systems..