6cell or 8 cell with my set up

[Southwest]

........Better info in thread.

[Engelkefarm]

Sorry yes you are right 1050 it is typo there

[Engelkefarm]

Any good suggestions on motors on 6cell. I am not going to replace it immediately but I want to keep the batts just swap the motor out eventually.

[madmikepags]

Way way way way way way way UNDERPROPPED you are at 23.000rpm I had a conquest and a Herzog hurricaine both with Lehner 3080'2 with an RPM of around 25,000 and I ran a Y572/3bladed prop. the 3080 produced 8-10,000 watts, The problem you have is that motor is rated at about 3000 watts and I suspect that is even on the high side realistically on 8S it might be 2200-2500 watts, on 6S is not powerful enough to pull a prop big enough to move your boat.

[madmikepags]

a Neu 1527/1Y (1250kv) is the perfect 6 cell motor, If you want more power than that then a 1530/1.5D (1350kv)

[Engelkefarm]

Yea mike we figured out the motor is under powered so therefore cannot run the appropriate sized prop. I will get a new motor next season. It runs pretty well the way it is set up. Ps 3000 watt will cook the wires on the motor I don't care what Hk says those wires are thin

[blowNover]

Just going to through this out there on a real boat when someone wants out of the hole harder acceleration the up the blade count. Think of ski and wakeboard boats. There is a reason they don't run two or even three blade props. Most run 4 or 5 blades. My friend you worry about coming of the line actually seems more like a drive angle/depth issue to me. But that's just my two cents.

[Engelkefarm]

I know about real boats have a Daytona 25. With a 496

[Engelkefarm]

The strut is up as high as possible rudder is offset. Strut is at neutral angle

[madmikepags]

there is nothing wrong other than his KV is way too low for the cell count. yes even on our little boats inc blades inc acceleration.

[Engelkefarm]

Would a leopard 4074 or 84 work well on 6s what kv should I be looking for?

[madmikepags]

kv between 1250-1500 IMO

[Rumdog]

I'd go with a kv around 1600. That hull doesn't do well with big props being that its so narrow, so it's best to get rpms up kinda high

[iridebikes247]

I would get tp power 4092 motor in the 1500 1600kv range. Run 6s m445 prop. That motor is a powerhouse incomparable to leopard. In time buy sf 240 esc and 85mph is yours on 8s.

[Engelkefarm]

Bike rider that would involve me changing everything batt esc and motor. I do not need 80 mph 50-60 is fine with me