Apparition on 6s with typhoon 1800kv

[FighterCat57]

Ok so I switched out the Turnigy 180a esc with a 120 Turnigy aquastar.
The 180 went into the Genesis
and I am not very impressed with it. The boat seems to runs much slower.
Only thing I can think is that the timing is off. options are as follows
Right now I have it on Auto does anyone have experience with these ESC's?

Option 1: Low advance timing
0°~15°
Recommended for more lower pole count motors. Gives more power and
slightly less efficient.

Option 2: middle advance timing
5 °~ 20 °
Recommended for most motors .Gives a good balance of power and efficiency.

Option 3: High advance timing
15° ~ 30 °
Recommended for most of higher pole count motors
Option4:Auto(default)
Recommended

15 degrees on the outrunner

Hmmm...never thought of going the outrunner motor method. Didn't realize it was cheaper!!

Do you think this motor on 4S would be good in a BJ26 length 26 7/8in (660mm)? Maybe 6S if propped correctly?

Or be able to power a 30+ inch Vegas brushless conversion on 4S? 32.25in (820mm)?

JMO, but go with the T600 (3kwatts) or 3126 (1.5kwatts) 1600kv or 1300kv.

[Graeme]

So you think option 2 or option three or try both ?

15 degrees on the outrunner

[FighterCat57]

So you think option 2 or option three or try both ?

Option 3, outrunners are high pole count motors