Apparition on 6s with typhoon 1800kv

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Graeme
    replied
    I tried the typhoon in my genesis today and it sucks.
    too much boat for the motor.
    It's slower than stock and gets too hot.

    Leave a comment:


  • Graeme
    replied
    I have run this set up lots on 4s2p very reliable everything stays cold.
    It runs a constant 40mph and last 15-20 minutes on 5000mAh packs.

    I have not tried 5s to see if things stay cool.
    I would imagine it's just a matter of finding the right prop combo to run 6s and keep the heat down.

    The only thing I modified to make the motor fit was the motor.
    I cut around 5mm off the shaft as it was much longer than stock motor shaft other then that it bolts right in.

    I should have my Genesis this week and I am going to try this motor out in it as well.

    Leave a comment:


  • Pompel
    replied
    Have you tested the boat more with this setup?
    How many cells do you recommend for a trustworthy boat? Is 6 cells too much?
    How long run time you will get with this setup?
    Was it just to bolt the engine right in or was it much modification?
    I wish to mount the same engine as you are in a Genesis, but is unsure how many cells and how many mAh I should run?

    Leave a comment:


  • FighterCat57
    replied
    Originally posted by Graeme View Post
    I think that with a small gps I could probably get there the one i am using weighs more than one of my lipo packs.
    where does one buy a cheap light gps from ?

    I am loving this set up I bought the typhoon for the surge flusher and never installed it before I sold it.
    Look for a Forerunner 101-301 or Foretrex. Nice, small and simple. That's what I use. I'm still trying to get my Apparition to break 60 reliably...

    Leave a comment:


  • Graeme
    replied
    I think that with a small gps I could probably get there the one i am using weighs more than one of my lipo packs.
    where does one buy a cheap light gps from ?

    I am loving this set up I bought the typhoon for the surge flusher and never installed it before I sold it.

    Leave a comment:


  • FighterCat57
    replied
    Originally posted by Graeme View Post
    I wonder if I can break 60 with this set up will have to try a smaller prop and a smaller GPS.
    I'm not so sure. More like 55 I think.
    Running T180 CC/Neu 2650Kv on 4s w/440 was 58mph (39k RPM) and had to go up to 8mm motor bullets. I melted the solder connections on the Castle 6.5mm bullets. Probably could have gotten 60 w/442 but kept breaking the drives... Too much RPM.

    Depending on your lipo weight and I think the Typhoon is lighter... might get close to 60.

    Leave a comment:


  • britscoot
    replied
    I'm going to put that typhoon motor in my red evo!
    will try it on 4s and work my way up!
    Small prop also.

    Wish me luck....hahaha

    Leave a comment:


  • Graeme
    replied
    I wonder if I can break 60 with this set up will have to try a smaller prop and a smaller GPS.

    Leave a comment:


  • ray schrauwen
    replied
    Yes, it should be at 15 degrees.

    Leave a comment:


  • Graeme
    replied
    the other thing I changed was timing from 11.25 deg to 15deg
    not sure if that had an impact on the motor heat or not

    Leave a comment:


  • Graeme
    replied
    on 4s it runs a sold 43mph and cool i think it will be a good reliable set up of 4s
    my gps is too heavy and causes a bad list so it's probably more like 45

    I definably need a smaller prop for running on 6s motor temp was 150 esc was 80.
    and something was smoking I am hoping it was just the 4mm bullet connects. I have larger ones on the way.
    anyway here is a video on 6s it flys
    IMG_2596.JPG

    Leave a comment:


  • Make-a-Wake
    replied
    I wonder if a 38mm prop would bring the temps down just a tad on the motor, and maybe even let it rev out a bit more...........may end up being as fast but cooler............????

    Leave a comment:


  • Graeme
    replied
    Yeah I can't believe the torque difference and the sound they just sound mean.

    I will try to post a video soon.

    I think I am going to try one in the genesis cat when I get it.

    Originally posted by FighterCat57 View Post
    Cool! The outrunners seem to be the way to go!

    Leave a comment:


  • FighterCat57
    replied
    Cool! The outrunners seem to be the way to go!

    Leave a comment:


  • Graeme
    replied
    I did try it on 6s I see the confusion I was not too clear in my explanation I will change it
    thanks.

    Leave a comment:

Working...