hydra 240 lv & 10 xl question ?

[Jeepers]

A 437 prop will not push a 33" mono efficiently, at all.

Depending at what rpm your turning that prop, while its not the most effciently set up it will work.

[Jeepers]

maybe so. They say you can run 6s on hydra lv but I belive they are more reliable on 4s I'll pick up 120hv for the 11xl and see what happens

I have seen these speed controls work just fine on 6s with reliable setups and survive. YOUR set up was to EXTREME for the motor, the weight and prop a 445 on a 10xl is a 4s setup not 6s.
OBVIOUSLY, you guys need to rethink your high voltage low amp set ups before putting a boat in the water, CAUSE YOUR NOT PULLING LOW AMPS!

[Make-a-Wake]

With the 11XL a 640 may work well.....................or a 442

[lrm50]

I've seen guys run a 10 xl on hv esc on 8s. x447 prop. I figured the 10xl would bo ok on a 240 lv 6s setup expensive lesson learned. Would the 11xl on120 hv on 6s do the same thing?

[Flying Scotsman]

just built a 33 delta force With a hydra 240 lv and a 10xl feigao running on 6s 6100 and a x445 2 blade prop. What will happen with this set up?

This question begs the answer why did you set it up this way to begin with and then pose the question after it went boom. I do note your reply to BakedMopar but I still am at a loss to understand the thread. Do you have an Eagle Tree logger..did you test for temperaturers on initial runs and after how long...was the setup...wet?
The LV CC ESC's can not take 6S and aggresive props.
I would look at a 580L and a high voltage ESC and an EagleTree!

Douggie

[Jeepers]

I've seen guys run a 10 xl on hv esc on 8s. x447 prop. I figured the 10xl would bo ok on a 240 lv 6s setup expensive lesson learned. Would the 11xl on120 hv on 6s do the same thing?

answer this please why do you need 6s in a 33 inch hull???? and watching an 8s 10xl powered boat you obviously didnt stick around long enough to watch the

[lrm50]

The thread is to see responses to it and see if anyone has had a issue with that type of set up.1st day I had 645 prop on it and it ran fine a little warm like bath tub warm no issues but I did break the prop it was aluminum not berilium . Next day I tried a 445 on it boat seemed to be running the same except I noticed the motor spinning a little faster so I just played w/ boat and then puff the magic dragon. DAMN lesson learned

[lrm50]

answer this please why do you need 6s in a 33 inch hull???? and watching an 8s 10xl powered boat you obviously didnt stick around long enough to watch the

speed I love speed why else?

[crabstick]

speed I love speed why else?

you sure its not that you like ? haha

[RIPFENCE]

if you want to run 6s which does have its advantages..consider douggies post with the 580l big can motor or a feiago 12xl-13xl and a seaking 180 amp controller you should be alright...start with and x642 prop and work your way up slowly...check temps/etc..