Connecting an Etti Capp Board

**Steven Vaccaro** · 06-10-2010, 08:38 PM

Originally posted by LarrysDrifter View Post

Does anyone know where to solder the wires on and Etti capp board?Is it the "foil"squares or the dots of solder on the bottom?

**Steven Vaccaro** · 06-10-2010, 08:41 PM

Use an exacto knife to remove about 1/4" of the insulation and then solder to the cap board.

**LarrysDrifter** · 06-10-2010, 08:59 PM

Thank you very much.Looks like it gets soldered to the "square" part.Could I use 12AWG wire to make the connection instead of direct soldering?

**Steven Vaccaro** · 06-11-2010, 06:40 AM

I'm told ideally its best to limit the length of wire used. Thats why its pictured inline.

**Jeff Wohlt** · 06-11-2010, 09:44 AM

Larry, where in MO?

**LarrysDrifter** · 06-11-2010, 06:41 PM

Originally posted by Jeff Wohlt View Post

Larry, where in MO?

Festus.About 35 miles south of St.Louis.

Comment