Kbb 34" mono build

[Beaux]

I caught this one on sale so I thought I'd try it . I wanted to run 5s what esc would you recommend.

[Jcarlton]

hey travis where did you get that motor mount for the lehner ?

[kfxguy]

hey travis where did you get that motor mount for the lehner ?

It's just a kintec mount with a custom rear support ring. I have a few left if you want one. One ones in existence left that I know of

[Jcarlton]

how much did you want for one ?

[kfxguy]

how much did you want for one ?

$25 shipped. I have to modify them a little to fit tightly.

[Jcarlton]

well i have a 2240/5 motor and like your setup . i want one send me your paypal !

[Oliveirax]

@kfxguy Hello. I am building a tfl pursuit and I would like to install a flood tube. May I ask what is the internal diameter of yours? And its length? And even another issue: I have seen some installations where the flood tube is horizontal, i.e. glued to the keel. Yours seems to follow the angle of the motor shaft. Is this accurate? Thanks in advance. Love your builds.

[kfxguy]

@kfxguy Hello. I am building a tfl pursuit and I would like to install a flood tube. May I ask what is the internal diameter of yours? And its length? And even another issue: I have seen some installations where the flood tube is horizontal, i.e. glued to the keel. Yours seems to follow the angle of the motor shaft. Is this accurate? Thanks in advance. Love your builds.

If I remember correctly the flood tube was 14 or 16mm I.d. carbon tube. I do not remember the length but that will vary based on where you put the motor. The angle does follow the drive shaft. And thanks! I wish I still had this boat

[Oliveirax]

Thanks for the info!