Darin's 25" Radtek Mystic N2 Build

[Darin Jordan]

Added ONE new decal... I'll let you decide which one.

Also, Thunder Power came through with 2 new sets of their brand new "Magna 70C" series of cells.

These are supposed to be a new, improved chemistry. I haven't cycled them yet, but will be able to directly compare them to the Pro Power cells from last season.


Radtek_Mystic_2015.jpg
Radtek_Mystic_2015_002.jpg

[Darin Jordan]

Also, I added an ETTI Cap Bank, just because I had one. Going to fabricate up a couple of my own Cap Banks with some lower voltage Rubicon caps as well. Can't have too many caps!

ESC_cap_bank.jpg

[NativePaul]

Added ONE new decal... I'll let you decide which one.

Is it one cut up into several Pieces? I see a new Lehner Motoren Technica sticker on the front deck, one on the port side freeboard, a homebrew one on the motor can, one on the motor cooler, and is there another unseen (piece of) one on the starboard freeboard?

I hypothesize that you peeled the stock motor can one off for better thermal conductivity under the jacket even though it was made of foil.

1540/3LK?

[Darin Jordan]

Is it one cut up into several Pieces? I see a new Lehner Motoren Technica sticker on the front deck, one on the port side freeboard, a homebrew one on the motor can, one on the motor cooler, and is there another unseen (piece of) one on the starboard freeboard?

I hypothesize that you peeled the stock motor can one off for better thermal conductivity under the jacket even though it was made of foil.

1540/3LK?

Wow... WAY overthought that one! I very much appreciate the in-depth effort though!

I DID peel the motor sticker off, but only so I could fit the cooling can. I then put the sticker back onto the cooling can, and put a piece of clear heat-shrink over it to help preserve it. Get tired of not knowing what motor I have!

The rest of the stickers are just stickers... as LMT supplied them. OH, wait, I did trim one of them down a bit so it would fit onto the deck better. :)

Is it March 20th yet? :)