I just cant stop building these.................

[properchopper]

I think i may have to hold off on that one Tony...................i sniff out the big time bargains on Ebay..........get the old IV's for like 50 bucks sometimes..............

Rear end is basically done. My fingers in that little transom was not fun.................but it looks good and "blingy"! All thats left is the ESC mount and the stuffing tube support

Oh well, I just thought......

Looks great ! This one's gonna be worth watching. Vid's Vid's

[Make-a-Wake]

Well................watcha all think?

[srislash]

Looks ready to go M-a-W.Is that a trailer under her?Cool

[properchopper]

Nice tight install. Funny how a clean install doesn't tell of all the work it took to make it look so simple.

[Make-a-Wake]

Looks ready to go M-a-W.Is that a trailer under her?Cool

Yep, i made it myself out of aluminum stock...........here's a better shot of it haulin' another boat

[Make-a-Wake]

Nice tight install. Funny how a clean install doesn't tell of all the work it took to make it look so simple.

Thanks Tony.............yep, it wasnt a simple 'throw together' for sure as you are quite aware. Should be able to get her wet this weekend!

[lenny]

Looking good,
Do you still have that boat and what setup was in it ?
I have a stock one with two motor drive and was thinking of modding it.

Yep, i made it myself out of aluminum stock...........here's a better shot of it haulin' another boat

[Make-a-Wake]

Looking good,
Do you still have that boat and what setup was in it ?
I have a stock one with two motor drive and was thinking of modding it.

That's what mine was.................a "Syma" twin motor. I have a Feigao 3660 1898kv in it on 4s, single drive, Fun little boat.

[Eodman]

Too bad we can't find someone to make them out of fiberglass

[Make-a-Wake]

If you're talking about the Villain, i agree, fiberglass would be cool, but if you are referring to the Syma "toy" conversion,
suprisingly its some fibrous material...............stronger than ABS, look at this pic of it sanded bare before paint.

[Make-a-Wake]

Gonna get her wet tomorrow, son is in school so probably no vid, but it'll be a setup run so when i film it Sarurday she'll be ready!

Greased the shaft..........covered the front inside of hull with aluminum sheet, and sharpened and balanced the x442.

[properchopper]

Good Luck !!

[srislash]

"I love it when a plan comes together"

[properchopper]

[Make-a-Wake]

Well Tony....................as much as i hate to say it, lets just say "boing, boing, boing"................ran like a Kangaroo Have no idea why since i have two others that run great. The CG was a little farther back, maybe only 3/4", and i adjusted the stinger 5 times and the tabs twice. The differences I can think of are the stinger which is about 1/2" longer than my red one, and the prop has more surface area than the other two........... The stuffing tube exits the hull at the same point as the others......... got a bit of work to do as this baffles me.