I am in the process of building a boat for a friend It is comming out sorta cool so I thought I would share the progress.
The hardware on the business end.
The hardware on the business end.
-
-
One of my new motor mounts and the dual ball bearing setup. I have devised a way that both bearings come out of the strut to be repacked upon re-install. This saves the bearings from corrosion and early failure.
Last edited by RandyatBBY; 11-19-2009, 06:56 PM. -
A little more progress on the new motor mount I tested this mount at the 2009 SAW's pushed low 60ties on a new boat worked great!
Comment
-
Nice Randy, what's the diameter of the hole in the rear support for a 15 series Neu and split cooling tube cushion?Paul Upton-Taylor, Greased Weasel Racing.Comment
-
It is a 1 5/8 with a little hand work to fine fit. Motor mount kit for under $20.00 bucks!Originally posted by NativePaul View PostComment
-
Glued in the runners.
Stuffing tube built with water cooling.
Flex shaft and servo mount installed.
Boat is ready to paint and install electronics. All that is left for me to do is trim out the hatch and I am done with my part.
Comment
Comment