New catamaran project

[KillerDave]

Ha! I was wondering how long that would take... :-)
I placed a piece of GF under the air duct to close it off....

Thanks by the way! :-)

[Jeff Wohlt]

Damn, and to think I have been wasting 10 minutes painting all mine...LOL

[Alfa Spirit]

Nipple Connectors 90 Degrees M5 threaded are also available at MHZ, I bought mine at HOTR shop

http://206.206.85.209/xtdoc/Details.aspx?ProductCode=m-1591/D5&store=mhzusa

[Alfa Spirit]

I' ve sand the air intakes before glue them, it will be ok for paint and I build a small air intake on the front of the hatch

Exhaust or not


What do you think about Dave Marles job on Octura props?
The price is cheap for an Octura BALANCED and SHARPENED propeller Here' s the link

http://cgi.ebay.fr/PROPELLER-X442-ba...item53df1cf053

Thanks

[Alfa Spirit]

Hello guys, how can I do to build exhaust outputs, one on each side like Maritimo style ? That will be the last upgrade before paint, thanks

[Alfa Spirit]

Finally I won' t use Graupner adapter,

The stock HOTR with Thrust Bearing and 4mm to 3/16" Prop adapter. Propeller is an Octura X442

[Norman2]

Hello guys, how can I do to build exhaust outputs, one on each side like Maritimo style ? That will be the last upgrade before paint, thanks

Here is a photo of how I did mine, Regards
Norman

[Norman2]

Another Photo. Regards
Norman

[Alfa Spirit]

Thank you Norman

I love this cat like this

[Alfa Spirit]

I' ve got the carbon layer 200g/m2 Hexcel sergé, I will reinforce the bottom of the hull.
Sides are reinforced with fiberglass 44g/m2, lighter than carbon and less problems with Spektrum 2.4 GHz

[Alfa Spirit]

Hello guys, I hope you can help me.
I want to have a few props to make tests, now I' ve got X442, X642, 1742/3. What do you think about Prather 220, Octura X437/3 and GrimRacer 40x52/3?
My setup is 6S and 1510 kV brushless motor
An other propeller looks interesting, Octura 1.6/3 Diam. 40,6mm Pitch 73.2mm
Thanks

[KillerDave]

I love the carbon but I'm not brave enough to give it a go!
Just think that if it's in there, it has to look perfect!????

[tth]

Prather 220 would be good but dont waste your time with the x437/3 its too small in my opinion.

[j.m.]

I love the carbon but I'm not brave enough to give it a go!
Just think that if it's in there, it has to look perfect!????

if you lightly mist a composite fabric with 3M Super 77 spray adhesive, you can put a layer of waxed paper over the fabric. This will keep the fibers aligned and make it much easier to handle.

Applying epoxy to the surface of the part and then laying the fabric over the epoxy will release the 3M 77 from the fabric with almost no effort at all. It literally falls off.

Jon

[KillerDave]

Thanks Jon, Do I wait for the epxoy to dry first?