Hpr06

[westbeach]

Nope! I have AE-Carbontec's motor mount and I had my Neu 1521's mounted in my HPR.

mounting holes are probs diff, there's + hanspeters are designed around the 19"" series lehner motors so i was told... mounting my motors tomorro both of the drivers are now attached. orderd a eagletree with gps and some thunder power g4 30 / 60 c batts didn't want to chance china lipos

[vvviivvv]

mounting holes are probs diff, there's + hanspeters are designed around the 19"" series lehner motors so i was told... mounting my motors tomorro both of the drivers are now attached. orderd a eagletree with gps and some thunder power g4 30 / 60 c batts didn't want to chance china lipos

[westbeach]

You can get pre-cut C/F motor mounting plates and servo mounts together with the transom doublers for your HPR from AE-Carbontec. Email Andreas. He is a good guy to deal with. I bought my parts for my first HPR06 from him.

I am really wondering how all this equipment is going to fit in the hull and not make it sink! The water jackets on the 1527's are going to be a tight fit. I think I may have to make my own motor mounts...

[malibu1]

I am really wondering how all this equipment is going to fit in the hull and not make it sink! The water jackets on the 1527's are going to be a tight fit. I think I may have to make my own motor mounts...

[malibu1]

Sweet! Another build! I have a feeling everybody is going to finish before me. I am still ordering parts and waiting for stuff to arrive before I start building. Good luck on the build!

[toysRme]

Just sent the funds to Hanspeter on Tuesday for a HPR115 with the complete fitting kit.
Looking forward to seeing how your's goes

Ill just watch While I wait for mine to arrive

[vvviivvv]

I just thought the heat build up might effect the bearings

[elvish]

Why would you cut the shaft? Make them shorter? If so, not there is no problem, you can make them shorter, if you use a dremel be patient it might take a while.

[vvviivvv]

yeah, are you allowed to cut the shafts on those motors or will it throw them out of balance? my only worry is that i create too much heat and ruin the bearings...

[elvish]

hope you got the water-jackets too

[vvviivvv]

only 1521's 1527's are definitely gonna be overkill lol

[elvish]

hahaha the motors are huuuuugeee

[vvviivvv]

they came, took a month to get here aswell as a £25 customs charge will mount the motors tomorrow, are you allowed to trim the shafts or not? there like a inch and a 1/2 long...

[Cat-Boi]

use the blue 3m tape, wont leave any residue or risk pulling up the paint. 2 layers in key areas should protect it.

[vvviivvv]

Malibu ,

nice paint work , 1 suggestion mask the baby up so that you don't scratch it when adding your gear. BONEWAR

Strongly agree maskin tape the whole boat if you can...