WTB LSH Hull

[JimClark]

Looking for a good used LSH hull, strut and rudder (I have the batts, motor and ESC) . Not interested in a UL-1 and if it needs a little work that is fine. prefer the look of a scale hydro

[JimClark]

Boat found

[JimClark]

Back to looking again Anyone

[JimClark]

I can't believe how few Hydroplanes show up on this forum.

[JimClark]

Still looking

[flraptor07]

Jim I have a clean undamaged Popeye I'll sell.

[JimClark]

Tell me more? is it already to go with hardware, paint ect?

Pictures please and how much shipped to 98126

[flraptor07]

DSC02376.jpgDSC02379.jpgDSC02323.jpgYes it is, It's the Green and silver version, it has a nice hull mod that made a huge difference in how it runs. You want it with hardware and no electronics correct? It has some more decals on it now and I don't pics of it with them

[JimClark]

Yes no electronics. I already have a motor, ESC and batteries

[flraptor07]

To Washington state $300.00 shipped hull and hardware.

[JimClark]

Kind of concerned about that air trap area is it still sturdy there? Can I see an inside pic and transom?

What size flex shaft?

[flraptor07]

I put Monocoat black and clear decal on the top of the sponsons just on the light green part so it looks black and green checkered and then it has my NAMBA# on it too but all that will peel off.

[flraptor07]

Oh yeah it's still plenty strong, the area that I cut out is poured solid on the inside with Z-poxy mixed with milled fiberglass. The boat will decintagrate around it before that breaks!DSC02381.jpgDSC02319.jpgDSC02288.jpgDSC02328.jpg

[flraptor07]

I poured the area first then I did the cutting on the outside, actually I didn't cut it I used a Carbide burr for aluminum then carefully sanded smooth like a babies butt! Flex is 3/16" I ordered it custom like that and without any factory decals except the TFL Hobbies on the transom

[JimClark]

I need to read the popeye thread don't know much about them. Can i give you an answer tomorrow?