Wanted, LMT 3060 motors (2 off).
-
-
What Kv?
.ERROR 403 - This is not the page you are looking for
-
Looking for:
Hi amp LK series 30
5 windings
water cooling shell
200A Hi amp plug system if possible.Comment
-
For what kind of purpose do you want 1400 kv?????
On 10 s thats 50000 rpm Pulling 350 aComment
-
Want to run them with MGM TMM 40063-3 X-SERIES ESC's,
Motor data sheet below:
Comment
-
We understand the motor and ESC, what voltage will you use? That motor is normally used with at least 10S which makes the running rpm very high and the prop diameter relatively small. It is appropriate for SAW running but not usually for sport running. We just want to make certain you are not making a mistake.
.ERROR 403 - This is not the page you are looking for
Comment
-
I drive a 3060-10 with schulze32-202on 2x10s5000 wich gives 105 kmh for max 4,5 min in my 45 inch Buster mono that ways 9,4 kg
If you want to drive a cat on these motors you will have to put 2x10s each motor and then 3060 -8 will be a good choice
Yust look at this movies with 185 mhz mystics
3060-10 on 5x12 s 4500 mah fast enough i would think
Her with some optimised settings.
Just another ond on 3060-9 on 10s
This is my buster running a bit loose.... And only 25000 rpm with a octurax460
Rpm is not the only way to speed. But mostly will be the way to fry your controller. In no time..
RamonLast edited by rscheffer; 06-25-2013, 11:09 AM.Comment
-
Where did the OP say he was running 10s?
Seems like you guys are missing the obvious here...Comment
-
Why would he pay for a high-end 15S controller if he was going to only run 6S? I think you are missing the obvious.....
.ERROR 403 - This is not the page you are looking for
Comment
-
-
So does anybody have any for sale?Comment
Comment