whiplash 20 or IB FE30

[ray schrauwen]

More pics...

[ray schrauwen]

More...

[ray schrauwen]

Some more...

The last one is a finished pic showing the turn fin. All hardware is speedmaster and the hull barely has 6 runs on it with the motor shown.

It comes with all hardware, Dubro quick switch mount and attatched Ubec set at 5VDC unless you don;t want it. The servo is staying home as it is a $100 Futaba 9206. It is a standard size 20mm x 40mm servo. The rubber boot is old and will be replaced with a new one I have lots..

It ran fine with the 1500Kv PB motor but, I was using cheap cells that swelled up in there.

It's a tad heavy for me to run in LSH but, if you spend good $$ on proper batts and run an 1800kv motor it should run fine. I think it would be best on P-sport power.

When building I put thought into the why so much carbon kevlar up front... To bring the COG forward without using lead. It runs really nice but, before you say yes, I need to get it outside for bling pics, so you can see what it looks like today in the Dodge orange.

The price I gave you in PM is solid. Talk soon, I have a plate full of things to get done before 2PM.

Sorry for the delay!

Best regards,

Ray

[kevinpratt823]

Looks great, I'll take it.

Sent from my SCH-I535 using Tapatalk 2

[kevinpratt823]

I have a leo 3674 and seaking 180
Do you think this would work well on 4s, maybe even 2 5000mah 4s in paralell?
Sent from my SCH-I535 using Tapatalk 2

[Heaving Earth]

Nice boat.....
We gonna hafta have a hydro race.
Next time round I'm gonna run my Titan 29. Let's run again soon man. I want to see mikes atomic barbwire too.

[HydroMike]

What turn fin u have on there ?

[ray schrauwen]

I will be starting the pack up today and i'll let you know when I'm done.

Here are a boat load of pictures taken today showing what you are getting including shots of the few dings & blemishes. Really nothing major, the worst is the light chip on the sponson tip. New boot for steering rod installed and I swapped out the 5v Ubec for a 6v Ubec. I need the other for the Futaba servo I have. Not the best Ubecs around but it's DP270 encased.

Lots of pics and more to come of packing and boxing. I've been pretty busy, thanks for your patience!

[ray schrauwen]

Only 22 more to go...

[ray schrauwen]

12 more

Turn fin is 7075 Aluminum by Mike Hughes I think? Been a while, brand new.

[ray schrauwen]

Getting there...

[ray schrauwen]

Lastly....

[ray schrauwen]

Oops 2 more...

[kevinpratt823]

Looks great Ray! Just send me your paypal and I'll pay as soon as I get the message.

[ray schrauwen]

I think it would do well, a 4074 or 4082 2200kv would kick it up a notch.

I have a leo 3674 and seaking 180
Do you think this would work well on 4s, maybe even 2 5000mah 4s in paralell?
Sent from my SCH-I535 using Tapatalk 2