WTB: 1/4" Drive Setup, 12mm - 1/4 coupler

[FighterCat57]

I'm working on a big arsed boat and am in need of a 1/4" cable/Coupler setup. Can be threaded or smooth. The motor has two shafts, one on each side.

Not even sure where to start on this... I'll need the complete drive setup. Strut, tube, liner, cable, prop dog, washer, nut, etc.

Not sure what kind to go with. Open to suggestions. This is a high wattage setup, like potentially over 10,000 watts.

[Jacked1]

http://www.whhonline.com/Drives-s/8.htm

For a ready made 1/4" outdrive these guys are my fave, They aren't the cheapest but I have had good luck with them and they are in Florida as well with good customer support.

And I really want to know what you are planning on for this build! I found a very cheep 55in hull that will be up around the same power level.

[FighterCat57]

http://www.whhonline.com/Drives-s/8.htm

For a ready made 1/4" outdrive these guys are my fave, They aren't the cheapest but I have had good luck with them and they are in Florida as well with good customer support.

And I really want to know what you are planning on for this build! I found a very cheep 55in hull that will be up around the same power level.

Pushing the new ESC to it's limits. Have a 180kv motor that will accept 70v.
~10k RPM should work with some gas setups I hope. Might need a really big prop.

[blizard05]

Get in touch with Chris, dasboata@aol.com, he's a member here. Also try sales @zippkits.com, Joe has nice hardware at a good price. Larry

[Jacked1]

That is awesome!!!!
I have a feeling you are going to sell a ton (literally) of those esc's!