For sale BBY Full Carbon Fibre P hydro / Rigger WITH LIPOS
1st of it's kind ( soon to be in production by BBY) see the build Here
970mm OA Length x 470mm Width
Fully Built by Randy at BBY and race set up by SA Rigger Guru Wayne Schutte.
This is a Very quick OVAL boat on 6s it was GPS'd at 118kph, ( on old lipos)
Safty cutoff loop.
i have decied to get rind of all my boat stuff and get out of the hobby as it is starting to get out of hand and parts are hard to come by here in AUS , money is also a little tight at the moment.
This boat in in need of a new paint job!
Below is what you get and the cost i payed for stuff so you dont think i am ripping you off, this boat alone from BBY cost me around $3000 AUD with the Exchange rate. (poor exchange rate at the time)
I am open to offers but keep it real guys. if i dont get close to asking i will hold onto it, i'm not despreate or fussed that much.
FOR $1650 USD Shipped
THIS IS WHAT YOU GET:
BBY Full CF Hull
Cutom Ball beraing Hardware
Custom Motor Mount
NEU 1521 1y ( 30-35 runs new bearings)
Hydra LV 240 ( BRAND NEW ) (Approx $3000) AUD
1 x Reiciever Pack intellect 1600mah NICAD $30 AUD
4 x Hyperion Gen 3 VX 5500 3s lipos 5.5mm Bullets $440 USD
1 x BC-5 Balance charger $75 AUD
1 x Lead and balance charge set.
Shaft
Motor Coupler
3 x Racing PROPS
H7 B&S&DT and Modded with cup added (BY HPM models) $60 AUD
1445 B&S and Cupped ( cut down to 1443) $ 85 AUD
H5 Stock $ $20
All you need to race is you radio,
Close to $3800 AUD spent on this boat
This Boat hase NEVER been in a accident
Postage is VIA Australia Post Insured and packed properly with braces. $140
I am asking $1650 USD Shipped world wide. Offers accepted, but if you dont think it is worth please dont post or waste my time.
If the buyer is in AUS Some other Costing can be arranged with less postage and all.
1st of it's kind ( soon to be in production by BBY) see the build Here
970mm OA Length x 470mm Width
Fully Built by Randy at BBY and race set up by SA Rigger Guru Wayne Schutte.
This is a Very quick OVAL boat on 6s it was GPS'd at 118kph, ( on old lipos)
Safty cutoff loop.
i have decied to get rind of all my boat stuff and get out of the hobby as it is starting to get out of hand and parts are hard to come by here in AUS , money is also a little tight at the moment.
This boat in in need of a new paint job!
Below is what you get and the cost i payed for stuff so you dont think i am ripping you off, this boat alone from BBY cost me around $3000 AUD with the Exchange rate. (poor exchange rate at the time)
I am open to offers but keep it real guys. if i dont get close to asking i will hold onto it, i'm not despreate or fussed that much.
FOR $1650 USD Shipped
THIS IS WHAT YOU GET:
BBY Full CF Hull
Cutom Ball beraing Hardware
Custom Motor Mount
NEU 1521 1y ( 30-35 runs new bearings)
Hydra LV 240 ( BRAND NEW ) (Approx $3000) AUD
1 x Reiciever Pack intellect 1600mah NICAD $30 AUD
4 x Hyperion Gen 3 VX 5500 3s lipos 5.5mm Bullets $440 USD
1 x BC-5 Balance charger $75 AUD
1 x Lead and balance charge set.
Shaft
Motor Coupler
3 x Racing PROPS
H7 B&S&DT and Modded with cup added (BY HPM models) $60 AUD
1445 B&S and Cupped ( cut down to 1443) $ 85 AUD
H5 Stock $ $20
All you need to race is you radio,
Close to $3800 AUD spent on this boat
This Boat hase NEVER been in a accident
Postage is VIA Australia Post Insured and packed properly with braces. $140
I am asking $1650 USD Shipped world wide. Offers accepted, but if you dont think it is worth please dont post or waste my time.
If the buyer is in AUS Some other Costing can be arranged with less postage and all.
Comment