Proboat Miss Bud Hull

[silvr_tung_devl]

I bought this not too long ago with the intension of converting it to brushless, but other things have come up, so I've had to abandon this project.

F/S is this Proboat Miss Bud. When I bought it, it was completely RTR. I still have everything to make it RTR, but as it sits, is a bare hull.

Its the straight shaft version, but looking at it, it wouldn't be difficult to change out the stuffing tube.

I'm asking the following prices:
$125 for the bare hull
OR
$150 for hull and hardware
OR
$180 RTR.
All prices shipped in the lower 48.

Built RTR, it runs a Dynamite .15 nitro engine, with a JR Python radio.

If you want it RTR, I can certainly make it that way. The only reason I'm leaving it "stripped", is that most would convert this anyway....please ask any questions you may have....
I can provide my Ebay Feedback info upon request......Thanks!!!

Pics:

[silvr_tung_devl]

More Pics::

[wolf IV]

oh i want this but it would have to fit 2) 4s packs and a 1527..? doesnt look like theres eneph room whats the length?

[silvr_tung_devl]

Bow to stern is 26".
I don't think you can squeeze (2) 4S packs in there....I think you could get (2) 3S packs in there, though.

I can get measurements later and post them.

[silvr_tung_devl]

OK.....if you put batteries in the same location as you would in a Miss Elam, you have 30-35mm.

Looking at the specs on Elite 4500 4S, they'd just fit.

http://www.cheapbatterypacks.com/main.asp?sid=1606675&pgid=showlipos&man=ELT&cat=E30

[wolf IV]

Ok thanx. I think its just a little too small..