F.s. (2) lehner lmt 3080lk 5 wind

[thisisabook]

So. i need one not dual.

[robw]

shame they are 10mm shaft,

[jj2003]

shame they are 10mm shaft,

Jeff Wohlt makes a "Big Dog" collet for 10mm shaft, .250 flex. I just sold 2 sets of MBP collets the same config.

[robw]

sorry, I meant, shame they are 10mm shafts, I need 8 mm shaft for a truck,

[jj2003]

sorry, I meant, shame they are 10mm shafts, I need 8 mm shaft for a truck,

No offense my friend, Just an FYI,

[427Z]

I could use your advice on these and if it would be appropriate for the application I'm thinking of. I may be crazy for speed! I'm considering Storm Cat or a Cat in the 48"-50 plus inches. Would both of these be an overkill installed in a Large Cat?

To the monitor, I apologize if I am asking question in the wrong forum.

[photohoward1]

Not At all. I ran that motor in an R42 75plus easy. Not as a dual but single.


Sent from my iPhone using Tapatalk

[jj2003]

I could use your advice on these and if it would be appropriate for the application I'm thinking of. I may be crazy for speed! I'm considering Storm Cat or a Cat in the 48"-50 plus inches. Would both of these be an overkill installed in a Large Cat?

To the monitor, I apologize if I am asking question in the wrong forum.

Well, my honest opinion would be anything under 60" would be overkill unless you are running SAW. Even then, its gonna be heavy, BUT the power to weight ratio would be incredible!

[jj2003]

Memorial weekend viewing

"All gave some, some gave all"

God bless America and god bless those that laid down their all for our freedom.

NEVER FORGET

[jj2003]

Fathers day weekend viewing. Just in case someone wants to buy themselves a gift, or point someone in the right direction.

[robw]

Bit of a tip here, reduce the 10mm shafts to 8mm, then try car forums, i'm already running a 8mm 3080 in a 1/6th car so no advantage to me, good luck

[Drkrieger]

free bump for holy mother of motors!!!! I could put these is a darn golf cart!!!!!