Hydro & marine Chief

[Roy Van De Sande]

For sale:

-Hydro&Marine chief in carbon/kevlar + decal set
-MTC ruder 3 with 95mm bracket black
-MTC powertrimm midi black
-Lehner 2240/9 WK + motor support
-modellbaupirat collet
-OSE 150A 2-6s esc
-Savox 1256TG

Price: 850 $ incl. shipping to the USA.
Also for sale on another forum.

13329904_1119201331474905_201896015_n.jpg 13296313_1119197828141922_925526443_n.jpg 13296262_1119201294808242_237918909_n.jpg13296062_1119198231475215_1375459121_n.jpg

[nmnorth]

what is length and width of this boat ??

[Roy Van De Sande]

Lengt with overhang is 88cm (34,65') without 80cm(31,5').
width is around 25 cm (9,84').
If you have any more question -> ask please!

[Jesse J]

Beautiful boat! I could be interested in bare hull... But don't want to ask yet if parting it out.

[Roy Van De Sande]

Parting it out is a bit difficult since shipping to the US is expensive but I am open for any offers.

[Leeandre]

Ha seeds do you see on 6s ?

[Roy Van De Sande]

On 6s measured speeds were between 55 and 70 mph depending on the prop.
55 mph with an x442 octura, 70 with an Z48 from Hydro and marine.

[nmnorth]

i'll take it , Bill

[Roy Van De Sande]

ok, paypal is roy.vds@hotmail.com
If you give me your address I will make shore it is shipped tomorrow!

[nmnorth]

do you have z48 prop forsale too??Also , where are you located?? Bill

[Roy Van De Sande]

Hello Bill,

I am located in Belgium :) Package should be with you within 1-2 weeks normally.
I can provide the following props: Z43,5 - Z44,5 - Z46 - Z48 - octura x442 - x445 - x447.
Price for an RTR Z prop is 55$ only for you Bill (I don't sell them separately)
H&M sells these props too RTR but for 70$ a prop.
Price for a octura is 35$
Kind regards :)
Roy

[nmnorth]

Sent you pm, bill

[Roy Van De Sande]

pm back

[nmnorth]

Pm back

[Roy Van De Sande]

Sold to Bill!