I have the 32" Pursuit, Bling Rocket & 1m Osprey package left as far as hulls. Still have 5000mah batts & props.
Props: I will take $175 for all shipped
Osprey: $450 shipped
Pursuit: $350 shipped
Batteries: CHL $100 shipped
Dinogy: $160 shipped
prices OBO w/ Pay Pal
Original FS posts:
http://forums.offshoreelectrics.com/...ase&highlight=
Build threads, whether complete or still in project form:
http://forums.offshoreelectrics.com/...ild&highlight=
http://forums.offshoreelectrics.com/...uot&highlight=
http://forums.offshoreelectrics.com/...-up&highlight=
Props:
CNC cut aluminum from TP Power:
(3) pcs 45 x 1.4
46 x 1.4
47.4 x 1.4
48 x 1.4
38 x 1.4
39 x 1.4
TFL 1450 (JAE sharpened/balanced)
M445
M445
X440/3
X437/3
Misc plastic props
Osprey parts:
This was a prebuilt then stripped down. Does have a few spider cracks on it nothing bad. There is a little deformation where the epoxy heated up hull on bottom from factory where the wood touches (picutre of my hand hovering over area). I was going to sand it smooth prime & paint. Comes with stock rudder, tabs, fins and all hardware shown in picture. Replaced stinger with Speedmaster 1/4" (brand new). Hull already drilled for it.
I did the carbon/kevlar inlay. My first experience with the kevlar (and last). Some areas lifted a bit but all the critical areas seems to be down and secure.
Swordfish 240A HV ESC brand new. Sticker looks like hell but its new (bench tested only). Has brand new 8mm's all the way around. With program card and disk.
Hobby King 5692 1320kv & HRC waterjacket. Both brand new never used. Has 8mm bullets to hook into ESC.
Fightercat motor mount brand new.
Pursuit:
32" pursuit hull- white
Rudder- 130mm length. OSE-80050. It appears to be what normally comes on the pursuit.
Stinger- 3/16" 78mm long. This came from Fightercat and again appears to come on the pursuits.
Motor Mount: Carbon fiber 4-bolt 2-point mount
Driveline- .187" flex.
Motor: TP Power "4074" like size 2200kv
ESC: Hobbywing 150A w/ cooling tubes installed
Prop: M445
Bling Rocket
2868 X Power 2989Kv motor
HK cheap orange servo
120A Seaking
Proboat outdrive
PLEASE NOTE:
Osprey has many new parts. Motor, ESC, stinger, flex.. all new. Only used items is hull, rudder and trim tabs.
Pursuit basically new. Motor is new. Seaking 180 is tore down for a waterblock mod I was going to do. I lost a motor plug due to a desolder. I would say "as-is" on the seaking 180A esc...
Bling Rocket had maybe two runs on it...
The batteries are a bit older. The Dinogy's have never been used. The CHL were charged for the test runs of the mean machine & pursuit. All batteries are storage charged. "offered as-is no guarantee" as it is a battery.
Props: I will take $175 for all shipped
Osprey: $450 shipped
Pursuit: $350 shipped
Batteries: CHL $100 shipped
Dinogy: $160 shipped
prices OBO w/ Pay Pal
Original FS posts:
http://forums.offshoreelectrics.com/...ase&highlight=
Build threads, whether complete or still in project form:
http://forums.offshoreelectrics.com/...ild&highlight=
http://forums.offshoreelectrics.com/...uot&highlight=
http://forums.offshoreelectrics.com/...-up&highlight=
Props:
CNC cut aluminum from TP Power:
(3) pcs 45 x 1.4
46 x 1.4
47.4 x 1.4
48 x 1.4
38 x 1.4
39 x 1.4
TFL 1450 (JAE sharpened/balanced)
M445
M445
X440/3
X437/3
Misc plastic props
Osprey parts:
This was a prebuilt then stripped down. Does have a few spider cracks on it nothing bad. There is a little deformation where the epoxy heated up hull on bottom from factory where the wood touches (picutre of my hand hovering over area). I was going to sand it smooth prime & paint. Comes with stock rudder, tabs, fins and all hardware shown in picture. Replaced stinger with Speedmaster 1/4" (brand new). Hull already drilled for it.
I did the carbon/kevlar inlay. My first experience with the kevlar (and last). Some areas lifted a bit but all the critical areas seems to be down and secure.
Swordfish 240A HV ESC brand new. Sticker looks like hell but its new (bench tested only). Has brand new 8mm's all the way around. With program card and disk.
Hobby King 5692 1320kv & HRC waterjacket. Both brand new never used. Has 8mm bullets to hook into ESC.
Fightercat motor mount brand new.
Pursuit:
32" pursuit hull- white
Rudder- 130mm length. OSE-80050. It appears to be what normally comes on the pursuit.
Stinger- 3/16" 78mm long. This came from Fightercat and again appears to come on the pursuits.
Motor Mount: Carbon fiber 4-bolt 2-point mount
Driveline- .187" flex.
Motor: TP Power "4074" like size 2200kv
ESC: Hobbywing 150A w/ cooling tubes installed
Prop: M445
Bling Rocket
2868 X Power 2989Kv motor
HK cheap orange servo
120A Seaking
Proboat outdrive
PLEASE NOTE:
Osprey has many new parts. Motor, ESC, stinger, flex.. all new. Only used items is hull, rudder and trim tabs.
Pursuit basically new. Motor is new. Seaking 180 is tore down for a waterblock mod I was going to do. I lost a motor plug due to a desolder. I would say "as-is" on the seaking 180A esc...
Bling Rocket had maybe two runs on it...
The batteries are a bit older. The Dinogy's have never been used. The CHL were charged for the test runs of the mean machine & pursuit. All batteries are storage charged. "offered as-is no guarantee" as it is a battery.
Comment