F/s dasboata x648 prop

[kfxguy]

I have a new x648 I just got from dasboata. I tried it on my rivercat this weekend and my little motor just can't turn it like it needs to. I don't have anything else I can use it on so ima let it go. It's got about 5 mins run time on it. $40 shipped

[atechbh]

Would it work on my mean machine? I run 6s with a 1520 castle. 180 esc

[kfxguy]

Would it work on my mean machine? I run 6s with a 1520 castle. 180 esc

What kv? Truth be told this prop went 81.9mph on my 32" cat on 1800kv 1518 castle. I think the 1520 will turn it better than my 1518. That motor is about 500 watts more than mine... so yea. This prop runs super stable too.

[atechbh]

Mines 1600kv

[kfxguy]

Mines 1600kv

It should work fine. I've never had that hull so I can't say how it would work with it but if its at least as big as my boat I don't see a problem.

[kfxguy]

Btw, if it's bought before 11 am cst tomorrow I can ship it on my lunch break. If not I won't be able to ship till Thursday

[atechbh]

Mines only a 29" cat

[kfxguy]

Mines only a 29" cat

I'm not into selling stuff to people they don't need or might not work so I'd have to say this prolly wouldn't be the right size prop for that hull. I'd say 32" to 40"

[ray schrauwen]

This prop works very well in a 40" mono on 6S2P 10,000mah total, HOR SSS 1200kv 5684 motor for 4 minutes offshore racing.

[ray schrauwen]

If your not in a rush to sell it I could buy it up in a couple weeks. Going on a road trip. If some sales of my other boat stuff goes through tomorrow I could pay tomorrow possibly. If others jump in that's o.k. too.

[kfxguy]

I'm not in a hurry. I was actually thinking about detounging it and thinning the leading edge a little more to see if it helps. I think it will. I dunno. So many different ways I could go with props.

[dasboata]

The leading edge is thin enought the 600 series are very thin and then I tapper it down a little more and added cup to the tips !,,, Guys this is a really good prop,,just a seems like a little too much for his set up that is why I asked him to sell it on here, if you remove to much toung it might slip to much leaving the beach !

[kfxguy]

The leading edge is thin enought the 600 series are very thin and then I tapper it down a little more and added cup to the tips !,,, Guys this is a really good prop,,just a seems like a little too much for his set up that is why I asked him to sell it on here, if you remove to much toung it might slip to much leaving the beach !

I'll leave it as is and let someone else use it, i just dont have enough motor for it. it is a nice prop for sure.

[longballlumber]

$35 shipped? I have paypal ready

Thanks,
Mike

[kfxguy]

$35 shipped? I have paypal ready

Thanks,
Mike

I tell you what, $37 shipped and youve got a deal. thx