Miss Geico hull/hardware

[kevinpratt823]

SOLD MG 29 hull and hardware. Got it from a friend, set it up and ran it a few times, pulled the electronics now it's sitting on a shelf. Wood batt trays were removed, I ran a 4s in each side with foam on top to hold them down. From what I remember, I modded/drilled the strut to take a regular bushing(shortened) with a small sleeve on it. Has offset rudder, sponsons blueprinted, retrieval catch posts installed on tips and coated with plasti-dip(I assume), includes 2 flex shafts and collet. Has a few small chips in paint, and canopy has a small piece broken off in rear corner,(I put a piece of tape over it), I also glassed in a CF rod at the front of canopy to secure it a little better.
$120 shipped in lower 48 states
Not looking for "offers". Thanks for looking. SOLD
SAM_0432.jpgSAM_0433.jpgSAM_0435.jpgSAM_0429.jpgSAM_0428.jpg

[kevinpratt823]

SAM_0425.jpgSAM_0427.jpg

[Shane Lewis]

I'll take it, send me your email, I'll pm you my info as well

[Shane Lewis]

Can you please send the bushing with the small sleave that you used, not sure I would have one lying around?

[kevinpratt823]

Can you please send the bushing with the small sleave that you used, not sure I would have one lying around?

Of course.
Sold, pending payment.

[Shane Lewis]

Got it today, needed a lil cleaning but it's just what I wanted. Not sure who blue printed it but I'm gonna have to do it again but I was gonna do it to one anyway. Bought a new top so it's good to go after i get my new tp motors. Thanks for packing it so well

[Shane Lewis]

Here it is with a lil overhaul cosmetically, it has everything stock inside. The blueprinting wasn't far off. Painted it, anyway it's a feat boat and thanks again for the extras.