HPR 135 KBB Redemption (54")
Keith built and ran this boat at a saw event and I believe set some records with it. if I have the story correct, afterwards he was playing with different set ups and had a blow over after crossing his wakes and the boat stuffed sideways from what Im guessing. It is a Bullet proof layup but suffered from the crash. An esc tray that was bolted in thru the bottom pulled some of the screws through as well as the hull had stress cracks here and there. The left side took the worst of it. the hatch lip cracked slightly into the side of the hull and the side cracked along the seem. However, that crack did not go through the side completely. the inner layer of CF stayed intact. the outer layer of CK separated at that stress point.
The entire hull has been gone thru and fixed at a professional level and I have run it about a half dozen times on 2028 power and it runs fantastic. No excess weight was added during the repairs. If material was added, material was taken out first. In other words, no sloppy patches etc. the right side is intact paint wise. Sitting on my rack, most people never noticed anything cosmetic until I started pointing it out.
She comes Hull and hardware with custom c/f servo mount, HPR 12S slide battery trays, 1/4" MBP Click drives with two sets of 1/4" shafts (one for 1/4" props, the other for 3/16), HPR rudder and Hydraulic fakes and I have a low budget low pro metal gear servo in it that I will leave. A set of props and electronics will get you in the water.
Price is $1600.00 shipped lower 48.
Keith built and ran this boat at a saw event and I believe set some records with it. if I have the story correct, afterwards he was playing with different set ups and had a blow over after crossing his wakes and the boat stuffed sideways from what Im guessing. It is a Bullet proof layup but suffered from the crash. An esc tray that was bolted in thru the bottom pulled some of the screws through as well as the hull had stress cracks here and there. The left side took the worst of it. the hatch lip cracked slightly into the side of the hull and the side cracked along the seem. However, that crack did not go through the side completely. the inner layer of CF stayed intact. the outer layer of CK separated at that stress point.
The entire hull has been gone thru and fixed at a professional level and I have run it about a half dozen times on 2028 power and it runs fantastic. No excess weight was added during the repairs. If material was added, material was taken out first. In other words, no sloppy patches etc. the right side is intact paint wise. Sitting on my rack, most people never noticed anything cosmetic until I started pointing it out.
She comes Hull and hardware with custom c/f servo mount, HPR 12S slide battery trays, 1/4" MBP Click drives with two sets of 1/4" shafts (one for 1/4" props, the other for 3/16), HPR rudder and Hydraulic fakes and I have a low budget low pro metal gear servo in it that I will leave. A set of props and electronics will get you in the water.
Price is $1600.00 shipped lower 48.
Comment