F/s custom cnc carbon fiber motor mount sides

[kfxguy]

I had these custom made for my rivercat. Well it took a little longer to get them than originally planned. Had to make my own because I wanted the boat finished and that was holding me up. These work with the billet front plate and tail ring type mount (billet parts not included) . Because the way this mount is made, it can accommodate a good variety of motors. They are .095 thick. I'll take $25 shipped in the US for them

Pics

[kfxguy]

One more

[kfxguy]

Pics don't do these things justice

[monojeff]

I will take these.

[kfxguy]

You got it.

[devo]

Why did you have these made? Is it because you couldn't install a 40 series motor in that boat because it hit the floor? I actually had to cut out the bottom of my boat and put a piece of carbon fiber under it so the motor would fit. I molded the carbon fiber around a spray paint can lid and it turned out real well, plus the boat really hauls butt and has a nice low center of gravity

[kfxguy]

Why did you have these made? Is it because you couldn't install a 40 series motor in that boat because it hit the floor? I actually had to cut out the bottom of my boat and put a piece of carbon fiber under it so the motor would fit. I molded the carbon fiber around a spray paint can lid and it turned out real well, plus the boat really hauls butt and has a nice low center of gravity

I had them made because the mounts I had were aluminum sides and I wanted carbon fiber. I ended up making the ones I had in cf work because it took too long for these to get done.
Motor fits fine in all my boats. All I had to do in my mini was lay the motor down a little with some custom sides I made.