I just finished my Vans PX. I was just told by the Dr. I need rotator cuff surgery so I need to sell it. I have tested it a few times and on flat sticky water [ a lot of algie] . The best part, as seen in the short video, is that I can could go full speed into the turns. The dummy motor is one of the best I have ever built. The water out let is directed out of the top of the motor near the exhaust.
The bow has an dimple as seen in pics. I use wood and foam and I laid my trans. on the bow after it rolled over in a test. In Arizona we have sun and heat. After drying I ended up with a dimple. It is not cracked or broken. I will sell it RTR with a New in box Trans & recv. or hull and hardware only. Both including ship conus. If you want the stand you can pay the shipping or I can give you the address and phone of the the graphics supplier and build your own. It has a NEW proboat 1500kv motor and an Aquacrafts big cap ESC w/a 35v extra cap.
$500 hull and hardware $600 RTR Very firm
DSCN1715.jpgDSCN1712.jpgDSCN1711.jpgDSCN1714.jpgDSCN1741.jpg
The bow has an dimple as seen in pics. I use wood and foam and I laid my trans. on the bow after it rolled over in a test. In Arizona we have sun and heat. After drying I ended up with a dimple. It is not cracked or broken. I will sell it RTR with a New in box Trans & recv. or hull and hardware only. Both including ship conus. If you want the stand you can pay the shipping or I can give you the address and phone of the the graphics supplier and build your own. It has a NEW proboat 1500kv motor and an Aquacrafts big cap ESC w/a 35v extra cap.
$500 hull and hardware $600 RTR Very firm
DSCN1715.jpgDSCN1712.jpgDSCN1711.jpgDSCN1714.jpgDSCN1741.jpg
Comment