sold
Selling my delta force sniper 44 hull and hardware..the hull is done in vinyl and the hatch is done in rattlecan..the hatch could be redon because its a little dull looking..this was my first vinyl project so if you are looking for a flawless boat then this one is not for you..however if you want a stable high speed boat set up with some high end extras to drop a big motor in, then check it out..the boat has roughly 20 runs on it..i crashed the boat at over 70 plus and it resulted in a spider crack on the deck near the nose which i have shown in the pic..you have to angle the boat in the light to see the crack under the vinyl..also the vinyl can be easily removed and the hull is bare white underneath..here is the rundown
sniper hull and hatch 44.5 inches
carbon reinforced down the center of the hull
peter zicha motor mount for neu 2230
peter zicha servo mounting plate
hitec 7950th maximum torque 486 oz!!
Arrow shark shaft oiler
arrow shark hatch locks
exhaust dummies and 2 functioning mhz exhaust pipe water outlets
speedmaster rudder and 1/4 speedmaster stinger derive
china turn fins
speedmaster trim tabs
1/4 flex cable and octura 8mm to 1/4 coupler
asking $325.00 shipped complete in the usa
asking $275 shipped (without the zicha motor mount)
i have had some overseas interest in this boat but often the shipping cost to get it there is way too high depending on location..i will take offers from overseas but the shipping will have to be checked and will push the price higher of course
thanks for looking
rip
[ATTACH=CONFIG]92555[/ATTACH][ATTACH=CONFIG]92556[/ATTACH][ATTACH=CONFIG]92557[/ATTACH][ATTACH=CONFIG]92558[/ATTACH][ATTACH=CONFIG]92559[/ATTACH]
Selling my delta force sniper 44 hull and hardware..the hull is done in vinyl and the hatch is done in rattlecan..the hatch could be redon because its a little dull looking..this was my first vinyl project so if you are looking for a flawless boat then this one is not for you..however if you want a stable high speed boat set up with some high end extras to drop a big motor in, then check it out..the boat has roughly 20 runs on it..i crashed the boat at over 70 plus and it resulted in a spider crack on the deck near the nose which i have shown in the pic..you have to angle the boat in the light to see the crack under the vinyl..also the vinyl can be easily removed and the hull is bare white underneath..here is the rundown
sniper hull and hatch 44.5 inches
carbon reinforced down the center of the hull
peter zicha motor mount for neu 2230
peter zicha servo mounting plate
hitec 7950th maximum torque 486 oz!!
Arrow shark shaft oiler
arrow shark hatch locks
exhaust dummies and 2 functioning mhz exhaust pipe water outlets
speedmaster rudder and 1/4 speedmaster stinger derive
china turn fins
speedmaster trim tabs
1/4 flex cable and octura 8mm to 1/4 coupler
asking $325.00 shipped complete in the usa
asking $275 shipped (without the zicha motor mount)
i have had some overseas interest in this boat but often the shipping cost to get it there is way too high depending on location..i will take offers from overseas but the shipping will have to be checked and will push the price higher of course
thanks for looking
rip
[ATTACH=CONFIG]92555[/ATTACH][ATTACH=CONFIG]92556[/ATTACH][ATTACH=CONFIG]92557[/ATTACH][ATTACH=CONFIG]92558[/ATTACH][ATTACH=CONFIG]92559[/ATTACH]
? ONLY IF THEY WORK 
Comment