EVERYTHING MUST GO!!!! and Freebie

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • kburrows
    Senior Member
    • Mar 2008
    • 547

    #1

    EVERYTHING MUST GO!!!! and Freebie

    Brushless and Brushed stuff i have to get rid of.
    you pay shipping
    I take US money orders
    and Pay Pal

    Brushed first: ALL SOLD
    Basically a Aquacraft electric Hammer Kit....
    Transmitter,RX,and Servo (no crystals)$30
    ESC$25
    props and flex shaft, rudder $25
    550 motor no coupler $10
    550 motor unremovable part coupler $5
    i'll take $60 for all this and throw in two 380 motors with motor mounts


    back to the sell off...Batteries: All batteries sold
    2 - 9.6 volts 2300mah tenergy batteries(barly used 1 cycle) $30 (Sold)
    2 - 9.6 volts 2200mah Nunchuck tenergy batteries $15 with converter
    2- 9.6 v 1600mah batteries $15
    Freebie is the chargers and a y harness with the purchase of these batteries
    i'll take $40 for all this.

    Brushless stuff
    brand new 8xl, Installed and not runned $55(Sold)
    BJ motor (less that ten runs)comes with cooling and coupler $50 SOLD
    Brand new BJ transmitter & receiver no crystals $30
    Used RX no crystal $10


    Please post all offers here and PM address if intrested. Thanks for viewing.
    Thanks Everyone

    Flash is still available

    The flash is a low and suprisingly it self righting. I have brought it in evey time it flipped with out a rescue boat. Picture update This boat has a prop scratch on the rudder (not major), A extra hole at the rear for a servo arm(now sealed) one antenna hole on the stern, antenna now moved to the rear. Tiny nics and unoticeable scratches. The spot seen in side is where i used a lil gorilla glue to mount servo to avoid drilling holes. This is the hull cleaned and ready
    Attached Files
    Last edited by kburrows; 07-04-2008, 03:49 PM.
  • eclipse
    Senior Member
    • Oct 2007
    • 365

    #2
    interested in stinger thingy to the right of those motors on the left in pic 1 pm me
    just a kid with a super hawaii project

    Comment

    • kburrows
      Senior Member
      • Mar 2008
      • 547

      #3
      Do you mean the BJ Hardware? To be sure the bottom center in pic 1 correct?

      Comment

      • eclipse
        Senior Member
        • Oct 2007
        • 365

        #4
        yea how much you want?and does it turn if i does i dont want it uless its pretty cheap sory.need a stinger.
        just a kid with a super hawaii project

        Comment

        • eclipse
          Senior Member
          • Oct 2007
          • 365

          #5
          nevermind not interested sorry
          just a kid with a super hawaii project

          Comment

          • spicedcrab
            Member
            • Jul 2007
            • 79

            #6
            im currently looking for a flash to buy, is it the low one or the tall version? and can you get me a picture so i can give you an offer?

            Comment

            • Ocean Racer
              Senior Member
              • Sep 2007
              • 502

              #7
              Do you still have the Hammer hull?
              Failure is the First step to SUCCESS

              Comment

              • kburrows
                Senior Member
                • Mar 2008
                • 547

                #8
                No hull

                Dont have the hammer hull

                Comment

                • andym
                  More Go Than Show Prop Co
                  • Apr 2007
                  • 2406

                  #9
                  How is it self righting, very interested for my son.

                  Comment

                  • kburrows
                    Senior Member
                    • Mar 2008
                    • 547

                    #10
                    Its where you place the weight,when flipped a little water manages to get in, just enough to offset the boat and it flips on the belly.
                    Last edited by kburrows; 06-01-2008, 07:22 AM.

                    Comment

                    • SJFE
                      Fast Electric Addict!
                      • Apr 2007
                      • 4735

                      #11
                      Pm sent on the Bj motor.

                      Comment

                      • Doby
                        KANADA RULES!
                        • Apr 2007
                        • 7277

                        #12
                        $60 for the 8XL shipped to Ontario Canada !?!?!?!!?
                        Grand River Marine Modellers
                        https://www.facebook.com/search/top/...ne%20modellers

                        Comment

                        • kburrows
                          Senior Member
                          • Mar 2008
                          • 547

                          #13
                          Doby which service do you normally use when receiving somthing from the US? The prices listed does not include shipping, but without the cooling can i proably do $65 shipped, Get back with me on which service is best for you

                          Comment

                          • kburrows
                            Senior Member
                            • Mar 2008
                            • 547

                            #14
                            Bj motor still available

                            Comment

                            • kburrows
                              Senior Member
                              • Mar 2008
                              • 547

                              #15
                              Bump I now have Pay Pal, so get your order on...

                              Comment

                              Working...