40 inch carbon cat. stingers and brass tube x 2 are already installed, as are Turnigy Marine 180A x 2 and the water pick ups x 2 and the rudder with a 3rd water pick up. the water pipes are all in with the motor dumps going out 2 stern out lets, and the escs going out a side exit. also the radio gear is in. the motors are leopard 4082 x 2 are in place but require a permanent engine mount x 2 to be fabricated and installed. (i just rested them in and held in place with a very basic mount for a test run and weight distribution) on test run the boat flew! it leaped out the water on to the plane, unbelievable power from the motors. it was running on 2 x 6s lipo that are included, i would estimate that 1/3 throttle was giving me aprox 35mph, and with the props a have on and amp draw etc, the boat should run around 70mph. i will add some more pic as it looks now ASAP. cost me around £600 up to date looking to get £400 for quick sale ($630 / 510 euro)
it does require 1 new counter rotating flex shaft and one new prop. because i was inpatient and wanted to see it get wet, as I said above I used a very basic engine mount and in doing this, the motor/shaft line up went out, causing a failure and loss.
carbon cat 2.jpgcarbon cat 3.jpgcarbon cat 4.jpgcarbon cat 5.jpgcarbon cat.jpg
it does require 1 new counter rotating flex shaft and one new prop. because i was inpatient and wanted to see it get wet, as I said above I used a very basic engine mount and in doing this, the motor/shaft line up went out, causing a failure and loss.
carbon cat 2.jpgcarbon cat 3.jpgcarbon cat 4.jpgcarbon cat 5.jpgcarbon cat.jpg
Comment