Pursuit Mono kits.

[pyroM!KE]

well I was thinking 1800 kv on 6s..What about that?

[tiqueman]

She"ll do every bit of the speed you want. just check temps etc often when setting it up. ive not run an 1800, but Ive run a 1400 and a 1600 and both were pleasingly fast on 6S... not in a v hull tho, a cat, but still. If you look in the builds section, look at my FC 950 build, last vid was a 1600 tenshock motor and a 445 prop on 6S. Never got a gps on it, but Id say it was 60, if not certainly knocking on the door of it.

[Steven Vaccaro]

I couldn't advise 6s with a 1800 motor. I think you will end up with esc or motor heating issues.

[pyroM!KE]

I couldn't advise 6s with a 1800 motor. I think you will end up with esc or motor heating issues.

What about 1550kv on 6s?

[Steven Vaccaro]

What about 1550kv on 6s?

Sure thats a good setup.

But I cant break up the package as it is. I just dont have the time to swap the items around and then have to sell the stock motor as an open box item.

[cordecker]

Boat arrived and looks great. Have you had the chance to do any trials with different props to see what works the best?

[Drax21]

Boat arrived and looks great. Have you had the chance to do any trials with different props to see what works the best?

On a 2364kv 4074 motor, I am using an X442. With a 2000kv you should be able to use a M645. But a safe try may be the M445 first.

[Steven Vaccaro]

Boat arrived and looks great. Have you had the chance to do any trials with different props to see what works the best?

I use a m445. I haven't tested anything else.

[cordecker]

Thanks for the help. Will try the M445.

[singo]

hi there i am from australia, i am keen on one or two of these boats. where to from here? how long and much is it to get them to australia. thanks

[worriedsick4u]

What will it take to upgrade and put this in the 50+ mph range. And are you wiling to make those upgrades at an additional charge?

[madmorgan]

diesel has a good setup for his he said he was over the 50 mark i believe.

[Drax21]

diesel has a good setup for his he said he was over the 50 mark i believe.

Diesel was running a 2200kv motor with a M645. I too run (CC version though) this and if tuned it will come in at high 50s. With the 2000kv you will see low 50s with a nicely tuned set-up and more torque on the corners.

[Steven Vaccaro]

What will it take to upgrade and put this in the 50+ mph range. And are you wiling to make those upgrades at an additional charge?

Right now I'm selling them as they are. Sorry

[kola]

I got the one piece flex shaft but Im not sure how the install works? Does the soldered end get soldered onto the brass fitting? Also when removing the flex shaft they get pulled out from the motor side not the prop side correct?