Selling all ! New ; Swordfish, 1524 1D , MK II & hardware...

[2fast4u]

PM sent for motor

[2fast4u]

PM sent for hull & motor

[chummer]

[ATTACH=CONFIG]53939[/ATTACH][ATTACH=CONFIG]53940[/ATTACH][ATTACH=CONFIG]53941[/ATTACH] Alittle dirty and neglected but will be clean when i get done with it !

Congrats!!!

Everything road you travel will seem different now. Welcome, to a whole new world!!!

[rearwheelin]

She is defiantly neglected and needs a good home ! Lol

[Ksheren]

you have a pm

Kevin

[2fast4u]

Paypal sent for hull & motor.

[rearwheelin]

PP received for boat n motors . Thank you Wes !

[rearwheelin]

Just a update…will ship out this Wednesday.

[2fast4u]

Just a update…will ship out this Wednesday.

. Ok thanks!

[2fast4u]

Got the boat in. Thanks! Didn't see the small fe30 strut in the hull,but everything else was there. Good packing job! Also what prop would you recomend for this motor setup? Thanks Wes

[rearwheelin]

Wes was my bad on the strut, wasn't in there. I put it in another fellas bulk parts order.... My oversight. I will gift you some PP if that's alright or I can take it of the mount price.... I figure $10 off the mount.. I can probably squeez mount out for it with in a couple weeks . It will have 4mm motor plate and 2mm sides and will have aluminum ankers the side plates bolt to and that will be epoxied to the floor.. That's how I was going to do it, with no rear support. The motor can will need to almost touch the floor and you will want a shorter cooling can to so you can get max motor angle... PM what you think .... Randy

[2fast4u]

Wes was my bad on the strut, wasn't in there. I put it in another fellas bulk parts order.... My oversight. I will gift you some PP if that's alright or I can take it of the mount price.... I figure $10 off the mount.. I can probably squeez mount out for it with in a couple weeks . It will have 4mm motor plate and 2mm sides and will have aluminum ankers the side plates bolt to and that will be epoxied to the floor.. That's how I was going to do it, with no rear support. The motor can will need to almost touch the floor and you will want a shorter cooling can to so you can get max motor angle... PM what you think .... Randy

I'll take that deal on the motor mount, thanks a bunch! Just let me know when your ready to send it out and i'll send PP. Thanks Wes