I have race prepped and ran two Traxxas Spartans in attempt to get a 6S Q mono class going at the local club... but it never took hold.
Selling as a pair: $500 shipped cont US. Paypal preferred.
ask questions here - I will copy and paste any pm questions to the thread, so you might as well start there.
Both come with Traxxas radios as ARTR (add your batteries). Included in price is modifying connectors to fit your battery plugs/configuration (EC5 or 5.5mm bullets).
Boat 1 was purchased from LHS at retail price, upgraded with below details:
Strut raised roughly 3/8" and upgraded to more robust RC Boat Bitz (Austrailia), with matching trim tabs and stock rudder.
Aftermarket robust turn fins and Octura X445 prop, detongued, balanced and sharpened by me were added.
Acrylic sub hatch was cut to fit and mounting tabs added to eliminate water intake.
Motor is a TP4050 1570KV and stock ESC and servo, set up for two 3S 8000 mah in series with IC5 connectors.
Boat 2 was purchased as bare hull and all same parts as above plus unique custom designed and cut graphics by me.
Aftermarket water exit was added for dramatic effect and bling (the two faux exhaust ports on each side)
Motor is a Leo 4092 3.5D (1480 KV), Seaking 180 V2 (the really good ones) and ecopower WP servo, set up for parallel 6S batteries with 5.5mm bullet connectors.
included is one new flex shaft and original strut.
Selling as a pair: $500 shipped cont US. Paypal preferred.
ask questions here - I will copy and paste any pm questions to the thread, so you might as well start there.
Both come with Traxxas radios as ARTR (add your batteries). Included in price is modifying connectors to fit your battery plugs/configuration (EC5 or 5.5mm bullets).
Boat 1 was purchased from LHS at retail price, upgraded with below details:
Strut raised roughly 3/8" and upgraded to more robust RC Boat Bitz (Austrailia), with matching trim tabs and stock rudder.
Aftermarket robust turn fins and Octura X445 prop, detongued, balanced and sharpened by me were added.
Acrylic sub hatch was cut to fit and mounting tabs added to eliminate water intake.
Motor is a TP4050 1570KV and stock ESC and servo, set up for two 3S 8000 mah in series with IC5 connectors.
Boat 2 was purchased as bare hull and all same parts as above plus unique custom designed and cut graphics by me.
Aftermarket water exit was added for dramatic effect and bling (the two faux exhaust ports on each side)
Motor is a Leo 4092 3.5D (1480 KV), Seaking 180 V2 (the really good ones) and ecopower WP servo, set up for parallel 6S batteries with 5.5mm bullet connectors.
included is one new flex shaft and original strut.
Comment