F/S: Larsony, Seaducer, Bandit Shovel, Sidewinder, Cboxes

[kensmith]

Some RC Boats for sale (consider trades only on RC Helis):


1. Bandit Larsony (29")
$SOLD$>>>> has Fiego 8xl motor and Castle Barracuda 80 with water cooling installed, servo, rx, hardware and a special custom built turn fin, courtesy of Dick Crowe (thanks again Dick!). Much work done on sponsons for fast setup! Great boat for P-Sport Hydro or Q-Sport Hydro. ~$350 obo

http://ksmith8000.smugmug.com/Hobbies/Bandit-Larsony/11336878_eGMLP#788018081_cFEma

$SOLD$>>>>

2. Seaducer (33") has Schulze esc, hacker 8xl, seaducer hardware, servo and rx. Great setup for P-Mono. Very unique design requires no trim tabs or turn fin. FASTEST setup on smooth water or in position #1. Has won many races, and battle scars to prove it. ~$350 obo

http://ksmith8000.smugmug.com/Hobbies/Seaducer/11336884_XTVLt#788019252_NLGYV

3. Bandit Shovelnose (24") . elloggs #5 and Tucan Sam scheme, comes with 700 motor and astroflight esc, servo, hardware and Doug Robichard crafted turn fin (we miss you Doug!). Great hull for LSH or P-Sport Hydro class. ~$250 obo

http://ksmith8000.smugmug.com/Hobbies/Bandit-Shovelnose/11336898_iizAV#788018644_6CYrq

4.
$SOLD$>>>>H2O Racing Sidewinder (26") Gordon #24 scheme with Fine hardware/turn fins, 700 motor, servo. Great for P-Offshore class. ~$150 obo
http://ksmith8000.smugmug.com/Hobbie...96097348_tQHE9
$SOLD$>>>>


5. Danvo Crackerbox (20") (new in box kit), started assembly. Package to include motor, esc, servo, batts, rx if needed. ~$100 hull/hardware, 150 with motor and esc.

6.
$SOLD$>>>>Crackerbox (20") (fully setup and race proven). This one has many Batavia Nationals IRONMAN races. Fully setup and trimmed. ~$100 hull/hardware, 150 with motor and esc.
$SOLD$>>>>

*boat lengths are approximate, found numbers online as I am out of town right now. Can verify actual length before shipping.

I can make any of these RTR with Futaba 3PJ FM transmitter and receiver for additional cost.

Paypal only, paypal fee inlcluded only, shipping extra.

[mpg43]

can we get pics of both cracker box boats. Also interested in #1 put pics are not showing the boat, they are family pics. I am interested in mentioned boats.

Thanks,
Mark

[kensmith]

Mark: Here are a few shots to give you better idea of cboxes. The red one is shown in the one picture on the rack. It comes with two lids....regular one with no drivers and a custom lid with drivers to be NAMBA legal.
The other pics of the white Danvo is an old one of mine, but this one is like it but no hardware mounted yet, and no holes drilled. Only the driveshaft was installed.
Will get better pics when I can.

http://ksmith8000.smugmug.com/Hobbies/RC-Gear/11233504_Yskwq#796130237_4qhTm

[Karfrik]

well i tried the links an blank,no pics.I`m also interested in one of the C-Boxes if Salir doesn`t go for them.So 2nd dibs for me on those after him.But really need to see pics firsts.
Don`t want to be a PITA but aren`t pics mandatory when selling something here? are links permitted?....
Just want to see the boats,.....please let us know,....thanks,............Albert

[Diegoboy]

Thanks for the pics!!

[Brushless55]

good looking boats!

[Karfrik]

Now we are talking!!! thanks for the pics....couple questions;

1)boat #5 C-Box is the one(white) pictured right?
2)boat #6 C-box is not pictured,right?
3) whats the length for both C-boxes?
4)ABS?
5)any hardware close up pics available on both?
6) any ideas on shipping Conus?

Salir,you are first inline for them.I may be interested in one if they are 24-26" long but need to know shipping first,......thanks again for the pics!!!,.....Albert

[kensmith]

Now we are talking!!! thanks for the pics....couple questions;

1)boat #5 C-Box is the one(white) pictured right?
2)boat #6 C-box is not pictured,right?
3) whats the length for both C-boxes?
4)ABS?
5)any hardware close up pics available on both?
6) any ideas on shipping Conus?

Salir,you are first inline for them.I may be interested in one if they are 24-26" long but need to know shipping first,......thanks again for the pics!!!,.....Albert

1). Boat #5 (Danvo Cbox) is just like the white one pictured. That picture is of a previous build, but same type of kit. The one I have now is unbuilt except it has had the drive tube and propshaft installed but not the hardware or anything else.
2). Correct, Boat #6 is pictured below on the rack (hard to see) but it is a different kit (dumas I think).
3). Length is around 20" .....1/10 scale crackerbox intended for 05 type motors.
4). Danvo (#1) is ABS, #2 may be a different plastic type but not fiberglass....definitely plastic.
5). Will have to get better pics of hardware when I get home
6). shipping for cbox would be pretty cheap (~$10-15), larger boats a bit more ($15-20)

[Karfrik]

Will pass on the CBBoxes then,thought they were bigger.Love that boat rack thou!!...3 boats in one,..excellent!!.......Albert

[kensmith]

deal pending on #3 and #4 rest still avail.

[Jeepers]

1). Boat #5 (Danvo Cbox) is just like the white one pictured. That picture is of a previous build, but same type of kit. The one I have now is unbuilt except it has had the drive tube and propshaft installed but not the hardware or anything else.
2). Correct, Boat #6 is pictured below on the rack (hard to see) but it is a different kit (dumas I think).
3). Length is around 20" .....1/10 scale crackerbox intended for 05 type motors.
4). Danvo (#1) is ABS, #2 may be a different plastic type but not fiberglass....definitely plastic.
5). Will have to get better pics of hardware when I get home
6). shipping for cbox would be pretty cheap (~$10-15), larger boats a bit more ($15-20)

Hey I have that yellow/purple Viper in the picture sitting in my garage!

[kensmith]

Hey I have that yellow/purple Viper in the picture sitting in my garage!

I thought I misplaced that......I will be by later to pick it up.....
Hope you are enjoying it !!!

[obrien]

Is the bandit still available?

[hebner]

I used to own that yellow purple viper also was a great running boat when when I had it on 700 motor & NIMH. I bought it from Ken several years ago and sold it to some one in CO. Was a great boat.

[kensmith]

Is the bandit still available?

Actually both Bandit's are available, which one are you interested in?